I replaced my dead factory tpms valve with these. I have fobo 2 sensors. They work perfect. They allow me to air up while not removing the sensors. Worth it for me
1. I bought 3 T-valves. Two for the bike and One for my spare rear wheel. I found that the first two both had a bad schrader valve. The center pin that pushes in for air were bent or easily bent and would not return to the sealed position. Luckily I have new spare schrader valves That I could use.
2. The second problem was not the units themselves. But, they are tall, and when installed on the rear OEM 2005 wheel, they are too close to the fork arm. I could not install my TPMS sensor that I was using. Again, I was lucky. I have a different manufactured TPMS System with the sensors being about 2mm smaller and they would fit. Tire Gard System would not fit. Sykik Rider SRTP-300 did fit. I think FOBO Biker 2 also fits.
I purchased it for use on my 2018 CSC Trike-DCT Tour GW, for which I added TPMS since I lost the rear OEM TPMS with the conversion. As with most after-market TPMS, they suggest using metal valve stems; thus, I made the purchase. This will provide stable-rigid mounting to the TPMS valve stem-mounted TPMS monitors. The product was as described and gave me peace of mind of mounting to a rigid valve stem, particularly for the two rear car tires with rubber-mounted valve stems. Good quality chrome as well!
I took these “T” valves along with my new Bridgestone tires that I purchased from wingstuff to my local Honda motorcycle dealership. They showed me that the stock valves on the 2012 Goldwing are permanently connected to the TPMS sensor. These T values can not be connected to the OEM tire pressure sensors. Per the Honda mechanic, if he installed the new “T” valve on my Goldwing, he would need to remove the built-in TPMS and thus the TPMS warning light on my dashboard would be on all the time. Thus, I chose to return these “T “ valves for a refund. I wished Wingstuff had explained this incompatibility up front before my purchase.
These items really make life easy when you need to top off a bike equipted with FOBOs. You don't lose air as you try to put the fobo back on as you don't have to remove it. I just wish they would make one to fit a trailer wheel as the tire valve hole is too big for the T valve to seal properly on those rims.
This is a great addition to the FOBO's. that way you dont need to take them off to add air. Tires tend to lose air over time, so these make topping the tires off very easy.
I STRONGLY RECOMMEND the T-Valve stems when you purchase the FOBO Bike 2 TPMS unit. Super convenient to be able to add air without removing the sensors. Sure glad it purchased both.
Contact Us
