Contact Us
| Easy to install, easier for my passenger to hold onto, and gives me a place to tie off my seat bag. |
| Always put safety 1st . This item is better than an American Express credit card never leave home without it . |
| Second time around I used an adhesive primer to help keep them on the bike, it worked great. This item makes your bike look great. |
| Purchased a few days ago it was smaller than I expected but does an outstanding job , sturdy no worries about it falling off. |
| My hands were quickly numbing and clenching due to the factory narrow grips. I bought these because they were advertised to fit over the origional grips and still allow the heated grips to function properly. They are very well made, extremely comfortable and easy to install. The heat works well they look great! |
| Works well on a 2009 GL1800 VIIA-IICM, gets around the heel shifter OK, but the bolt portion must be *very tight* so that the extension does not slip up the kickstand shaft |
| Good Deal and great tires. Shipped and arrived in two days. Installed and no issues just a smooth quiet ride. Look forward to wearing them out. |
| It fit my Wing perfectly |
| They say they mount tip forward, back or level. Also make sure you buy the correct adapters. I called WingStuff and talked to the gal there to confirm I bought the right ones. She was very helpful. They did not mount looking level on my 2018 Gold Wing Tour. I ended up tilting them back one notch, one notch the other way and they tilted forward. They do not tip up very much on the Wing . They do look good on the bike and my feet seem to like them. |
| This looks great once it is on. Have to see how well it works when riding in the rain. My only suggestion is to make sure you measure twice and drill once for the holes. Installation error on my part. I had to expand the hole on the extension because I was off a bit on the fender. I just used some gorilla tape and a bit of epoxy on the hole to make sure the extension was solid. And I did use a chunk of wood to protect the tire when I drilled. |
| I don't know if it's me or what, but the center stand doesn't want to retract completely up. So be careful if you have the same issue. In addition, I would think the attaching technique, for the spring, would be better. It's a mushroom design as apposed to a hole or some type of clasping design. The directions are pretty bad. Could only find one third-party video on installation. |
| This went on easy, took a bit to find an adjustment position I like. I used this with the half boards I purchased here. The half board makes it more difficult to get under it to toe shift with it. I may move the half board back a notch to see how that works. I do notice I hit the motor with the toe of my boot more with this shifter than with the stock one. The heel shift took a bit of time to find compared to my old bikes, since it does not stick out as far. I am sure that will change as I ride it more and have developed muscle memory. I did talk to Honda about concerns that having it on might void the transmission warranty since it was not stock. I figure if I have a transmission problem I will put the old shifter on before I take it in. |