Contact Us
|
As you would expect from Honda, yet another quality product and well worth the money. Not only does it protect against stones and bugs it also looks good and easy to clean. I only use it on long trips and it is very easy to fit and remove. If you have fairing accessories like Baker Built wings and other chrome bits, then it can be a bit of a challenge to get a snug fit, but once you get the hang of it, it's really not a problem. It will stretch a bit over time to hug the fairing for a better fit (like gloves). Get one, you will love it! |
| Look very nice and are easy to install. |
| Look very nice - but I had to use the old metal inserts from the old knobs to get these to fit. |
| Very nice looking and fit's very well. |
| This is a must have to help keep from scratching up the ignition area. |
| Very nice looking and seem to be well made ---- BUT there are some major issues with these units. Mainly the problem is that IF your fairing or engine guards are even the slightest bit off YOU WILL break one if not both of these units trying to install them. |
| These took about 30 minutes to install. They really finish off the rear end of the bike. Very pleased with my purchase! |
| Tidies up the inside of storage compartments, stops gear sliding about so much in trunk when only partially loaded, awesome fit |
| We have one of these on the throttle side and love it. So much so I added one to the left side and same result--better comfort on a long ride. Money well spent. |
| Fits right on bike, you don't even need to align or measure. Wife and family gave lots of compliments |
| I installed this a few weeks ago and I waited to see if any crack would develop. I'm posting this for my fellow riders, it's something I figured out..Ok it's not the holes that you drill that are causing the cracks. It's when you tighten the screws that attach the front fender to bike. I found out because the Fork Tower are metal and don't flex when you thighten the screw it pushing out ever so slightly thus causing the crack. I found this out when after a few days checking to see if any cracks had developed and I started seeing pressure creases in the plastic. So I backed the screws out a half turn.(After I took them out completely and put some temp lock tight on them, since they would not be all the way in to give it some extra grip) And so far the pressure creases have stopped and no cracks have developed because of it. Try this when your installing these and see if it works for you. Tighten it all the way down then back the screw out a half turn and it should help. |
| I had these installed and they make a huge difference. The OEM grips are way to small, and my hands woulkd cramp up when riding. IU had these on my Roadstar Silverado and loved them. As far as feeling the heat, I only tried the heat for a short distance and barely felt anything. Hence the 4 stars..I hope that's not the case when it's COLD! Only time will tell! |