

| I had this on my Christmas wish list and Santa got it for me. I waited a few months to install it, just because I was lazy. Finally, I opened the package, read the directions, and five minutes later it was on and looking good! I was concerned about how it would hold up at freeway speeds, but that concern was put to rest immediately upon my first ride with it on. I didn't even test ride it; I just took off from San Diego and headed for Washington. On my 2500+ mile round-trip, it stayed put with no flopping around or fluttering. It fits perfectly and stays positioned as installed, plus it's easy to wipe clean with just a little water and a microcloth. As long as you're careful while removing the plastic edge trim on the fairing, you'll have no problems installing this product. Just use your fingers and pinch the edges of the plastic trim pieces to remove them; don't use tools. You don't even need to remove the entire plastic trim pieces; you only need to lift them back far enough for the end tabs of the nose mask to be secured by sliding them under the plastic trim. Installation is pretty easy and you'll like the new classy look of your bike. |
|
Purchased these in April 2015 and installation took less than 1 hour taking my time. Went for a 200 mile ride over the following weekend and found they do what they claim. No Vibration, zero nada! Anything above 20mph it only gets smoother and you feel the control of the Trike improve. Unlike other reviewers I do not have a fork brace and saw improvement. I just wish they had an option for a trikes rear tires. |
| There is no $10 fix. Easy enough to get the lights and just wire in. Don't need $46 worth of plugs. Just as easy to wire straight in. |
| I purchased these in mid May 2015. Bought the $53 kit with the adapters. Now I have to buy the $23 kit from Kuryakyn if I want to use the plug and play. So it goes from the $10 price up to almost $80. It is probably cheaper for me to send this back and just get the $10 set and wire straight in with a little solder and a little liquid electrical tape. Done deal. |
| I just put these on my bike. Easy to install make the bike pop. they really look great. Now I have to put some more chrome on. |
| I put mine on with hairspray, a little tuff but went on ok. |
| I've completed two oil changes with this hp4s bike runs very smooth just re-order getting ready for my third oil change |
| wouldn't change oil without one! Good value, |
| Great price, why use anything else. Just use a piece of flex tubing to go over the muffler and down to the housing. |
| Easy installation, really increases footprint on the ground. Hopefully no more sinking in to the asphalt when using the side stand. Used lock title on set screw so hopefully it won't vibrate off. |
| Awesome look and easy installation! Really dresses up the bike! Would highly recommend. |
| I find that Honda just does it right. However, no one is perfect. This is a weak part. You can replace them at tire changes or just go in and have them break the seal on the tire and replace them now. Use this honda part or the all metal one, but keep them new. Wake up to a flat or go down on a long sweeper at 65mph, your choice. |