Contact Us
| The shipping container exterior box and the box the part comes in were undamaged when they arrived. It wasn't immediately apparent that there was damage. Since I had already opened the package, I couldn't return it per Wingstuff policy. Contacted Add-On and they sent a replacement for the side that was damaged. All they needed was a receipt and a photo of the damaged part. |
|
This was an easy install. 7/8" drill bit (used a wood flat blade). Drilled right in the cross hairs on the outside of the box direct center. The hole is perfect and snug fix. I use it with a 2 port USB element and it works perfect. Turns off with the key, works in accessory mode too. My unit can with a cigarette lighter in it. DO NOT USE IT. Went to pop it out and pushed it in and the 5 amp fuse blew as it should have. Had to remove the seat and side cover for a stupid mistake. I forget to remove it with the rubber cap over it. |
| I bought two of these air cushions. It was good while it lasted but, one of them did not hold the air, and I could not fix it and could not return it. For the price and no warranty, I think it is too much to pay. |
| needs more than one fastener needs to be improved |
|
i just installed this on my 2014 GL. It took me about 20 minutes. Pros: Stainless steel. Having worked with Stainless steel surgical instruments, in my opinion, this should protect better than Aluminum. it wasn't difficult to place on once I looked at what I needed to loosen. Found out when I took the lower front cowl screws off and loosened that, then the sides were able to be pulled out off the screws. The directions do not mention that. Cons: the front section doesn't fit as neatly as I would like, but it won't come loose during my riding. 4 stars because the directions are not as clear as they could be. |
| I went to Myrtle Beach for bike week, which was nothing but rain. I used this cover for the 1st time. I put it on the bike for three days. 1st it's not even close to being rain resistant, here is what else I found when I took it off: Even though it allows the rain to go through it, it stops the driving rain and the bike was wet but not soaked. The worst part of was all was the cotton undersides for the trunk and windshield was nothing but mold. After looking at the cleaning instructions it cannot go into a washing machine and so it looks like this cover did not even last three days!!! |
| Windshield works as intended, and both rain and sleet roll off while riding at highway speeds.Got caught in a late winter storm at high altitudes around Flagstaff, AZ temps dropped to 24 degrees with snow and sleet as I got to lower altitudes. None the less it is a very good product. My issue with it is it keeps sliding back down to lower position while riding. Installation was done at Mountain Motor Sports in Ontario, CA over a year ago and never had to raise the thing until this past April so had no idea it was slipping back down. |
| I am glad I found these reviews as I was starting to think I had big problems with my bike's stereo. I have a 2010 and recently installed the dongle and purchased two new bluetooth headsets. What a disappointment it was to turn on the radio and not even be able to recognize the sing being played. I initially blamed it on the small speakers but upon plugging my iPod directly into the headset AUX plug I realized the speakers sounded very good. The problem lied in the dongle or the bike stereo. So after much research I've now learned that I have spent $1000 plus and have a crappy system. I can't listen to the bike's radio as it is just noise. |
| This my friends is a must have in the detailing toolbox. I detail Wings on a small scale (word of mouth). I'm a retired guy who enjoys detailing. This product performs as stated. I'm quite certain if it didn't Rick wouldn't sell it.The shine is off the hook, application and removal is a snap.(apply lightly and repeat). I suggest a good cleaner first.. I use a product called "safe cut"...or a clay bar will achieve the same results. Don't forget this is an acrylic base product...So the surface MUST be clean and free of contaminates. As not to seal them in. Shine on my Sisters and Brothers |
| I made an adjustment that seems to work so far. I reversed the two bolts on the connection so that the fork shape seat mount slides down behind instead of the front and that gave me almost 1/2 an inch. We will see how it goes but it’s a lot better. |
| This replacement receiver didn't fit in to the actual hitch, too big, and the when I ground it down to fit and installed it, the ball was right up against the back black fender. |
| Does anybody know if it's possible to switch from Honda 10/30 full synthetic to this oil?? |