Contact Us
| This product is great when installed. had some difficulty initially, when trying to fit original spring goes in. other than that, overall, I really like this product. Floorboards are wide and adjustable and i can rest my feet while riding. |
| i would highly recommend this item and this time around i bought it for a friend of mine. very reliable and and long lasting. |
| Not having to remove the front cowl makes this a no brainer. It just works and makes it so much easier to change filters. |
| Once again wingstuff makes it super easy. I use a new one every oil change and they just work. |
| Genuine factory oem, doesn’t get easier than ordering from wingstuff and knowing it’s going to work. Makes it super easy |
| The 8’ length is good for jumping a bike. Clamps and wires are good value for the money and fit in a saddlebag real nice. The upside is not carrying a jump box that has to be charged to work, just throw them on the bike and hope you don’t need them. |
| Ordered one bottle to try it out. Works great and now I’ll order two at a time. A little pricey but it last a long time and fits in a saddlebag well. I haven’t found anything better so far and will probably stick with this vs trying new stuff. |
| The bike really needed something to break up all the black on the lower front and this trim did the trick! Easy to install, fits perfect, and just what I was looking for.One issue: The adhesion promoter packet was compromised and useless, luckily I had some extras in my inventory. |
| First impressions were quite favorable. They installed quite easily and took 45 minutes. Today was our first ride and wife was quite disappointed. The upper position was to far up and basically useless. The second position interfered with my left foot as I was stopping. A better picture with the three positions would of been helpful. Don't know if I can return them but will fill out form. |
| If you are looking to trade out the stock yellow turn signals for white with yellow sequential turn signals to match the rest of the front end lights, these are perfect. The white full time lights match the white lights that are milk plastic under the headlights perfectly. My only complaint is I wish those lights were brighter, but they are certainly acceptable. The sequential turn signal portion is beautiful with a very clear lens. You do not see individual LEDS which makes them look very high end. The turn signal function is bright and attention getting. Plug and play with the stock harness. Took about 30-45 minutes to install both. |
| Wow are these nicely made. Very heavy and installation was 15 minutes for the first side and 10 minutes for the second. The trick is to make sure you hold your fingers over the stock pivot point when you remove and install them to make sure you don’t lose / misalign the ball and clip. There are three pivot positions, but only two appear useful as the third pivot point is straight up and down. The foot rest pivots forward and away from the bike giving the driver room to put your foot/leg down at stops without interference when deployed. The base of the floorboard does extend a bit farther forward than the stock floorboards however and when the pivot bar is closed these are also wider than stock. My wife figured out quickly to pull up on them with the heel of her foot near the back for easiest deployment when underway as the heavy weight will keep the main floor board down. At first it seems reusing the stock spring with the retention ball will allow them to fall when stored upright for single riding due to the heavier weight, but that has not been an issue yet. |
| Overall 4 stars. Appearance materials and machining gets 5 stars. Ease of installing 5 stars. Heat transfer for heated grips is 3 stars and size versatility is 3 stars. These grips measured 2.74 inches in diameter with my calipers at the largest point on the rubber portion of the grips. I wear a size large glove and found them to be too large for me. If you wear an extra large glove or larger, these would be perfect for you. Machining and finish is top notch and installation is super easy. The rubber is grippy and gives you confidence in relaxing your grip. Heat transfer was just ok when using heated grips in mildly cold temps but I did.not get a chance to ride in cold weather. Overall very nice product if they fit your hand size. |
