Contact Us
ON SALE
-
Saddlebag Guard Covers Chrome for 2018+ Gold Wing
By Add On SKU: AO45-1623C
-
$39.99Save $62.96
MSRP: $102.95
-
-
-
Your Bike
Will this fit your bike?
-
Related Items
4 Member Reviews
1 Star: 0
2 Stars: 0
3 Stars: 0
4 Stars: 0
5 Stars: 4
Saddlebag Guard Covers Chrome for 2018+ Gold Wing
ITEM CODE: AO45-1623C, SKU: AO45-1623C
Better Looking
| I like that they seem to fit tighter than originals. This is because they have a gasket-like edge tightly fitting the muffler cover - so tight that I used a little WD40 to work it on. Once mounted, these pretty to look at additions are not going anywhere. |
Saddlebag Guard Covers Chrome for 2018+ Gold Wing
ITEM CODE: AO45-1623C, SKU: AO45-1623C
Great Quality
| Like the fact these install with original clip & no 2 sided tape. They really add to the look of my bike. |
Saddlebag Guard Covers Chrome for 2018+ Gold Wing
ITEM CODE: AO45-1623C, SKU: AO45-1623C
Nice Quality
| These are a little pricier than the other options out there but the quality is nice. Others mount over the factory plastic ones with double sided tape. These replace the originals and install with the same fastener clip. Thought I might not like the grooves type of styling but once installed they look great. Be patient when installing. You got to wiggle them a bit to tuck the rubber seals into the opening just right. Nice accessory. |
Saddlebag Guard Covers Chrome for 2018+ Gold Wing
ITEM CODE: AO45-1623C, SKU: AO45-1623C
Installs identical to OEM No Double Sided Tape
| Looked hard and compared to Goldstrike The deciding factor for me was that these install identical to the OEM covers. There is a two part plastic puch pin that is eaisly removed from the OEM covers using a flat head screwdriver. You must remove both the inner and outer push connector. If you ever need to remove the exhause covers you will need access to the space behind these covers. These come with the same rubber grommet as the OEM. There is a small channel that needs to be slid into place on the exhaust shields. Very easy to do, just start with lining up the channel with the exhaust shield, with the cover slightly tilted up, than lower the cover into place, then reinstall the two piece retaining connector. |