Contact Us
| Purty darn nice shirt! |
| Looks great after installed, gave me the fits trying to fit though. |
| If you look around you can find this item a tad cheaper. Super easy to install and really finishes off the look for your Wing. Like many others, I also switched out the OEM red LED display and installed the Electrical Connection version, a definite must do! It is not necessary to take of the seat at all. Two important notes that will make the install easier, if you look along the left edge of the passenger seat along the side of the wheel, you will see a small but ample opening where you can fish the three remaining bullet connectors (yellow,black,white)and be sure to fish the wire UP from the wheel and not down! Took all of 30 minutes, including a Labatt's Blue break! |
| Feel much better. Love them! |
| Hey, it's Honda! |
| The only way to go. Should be a standard item on every Wing. Suck it up, measure twice, cut once. |
| 7,000 miles later, not a blemish. Love them to keep the exhaust off the trailer and they look great as well. |
| Wonderful addition. The wife and grand daughter love me for them! Thumbs up on this one. |
| Not Goldwing intended IMHO. I've ground the tight side to the point the footpeg mounting ears have cracked, the bottom of the footpegs are ground through to the rubber. have them adjusted as high as possible. Nice product, just not enough adjustment for the Wings. |
| Perfect fit and comfort. |
| Another Kuryakyn joke. From the beginning. (1)The saddlebag claps are heim joint were apparently preassembled with a torque wrench. Had to pad bench vice to loosen fastners before installation could even begin. (2) The rear plate is attached using 4 clamps to frame. These clamps have a threaded insert predded onto the clamp. Supposed to anyway, one clamp did not have the threaded insert in place. Also be sure to run the bolt through the threads before installing to clean the paint from the threads. (3) Alignment of the saddlebag bar clamps & the heim joint was impossible on the left side. These clamps should have an elongated opening to allow adjustment. I had to modify the clamp to secure it to the guard. (4) The locknut that is supposed to be installed on the heim joint bolt is absolutely impossible to access. I checked another Wing with the exact same hitch, it was not on there as well. As stated before on another rating thread, the instruction sheets are nearly useless. I should have learned from previous experience with Kuryakyn products to stay clear. This venture has convinced me to do just that. If there were a rating lower than 1 star that would have been my choice. Far too much investment for this poor of a product. Installation time including needed modifications was 4 hours. |
| I think this is a great product. Mine was a tight fit, but fits like a glove. I like not having to worry about whether or not my remote or Gold Wing is getting beat up. |