Contact Us
| Make sure you do a couple of trial fits and have good lighting, so that you aren't thrown off by shadows. The fit is not very tight against the edge of the fender, but this is not highly noticeable. This is a nice trim piece which adds just a little chrome accent to the front, helping to balance out the bling-bling created by all of the chrome I installed on the rear and sides of my bike. I would have preferred a more simple, straight edge design like the rear fender trim piece I installed, but this was the simplest design available. Overall, its a nice looking piece of chrome. |
| These look great. They are made of lightweight plastic, so be very careful when unwrapping, handling, and installing them. One piece actually arrived with the finish slightly damaged by the rubbing of the shrink wrap. I used plastic polish to clean it up, so the blemishes are hardly noticeable now. When installing, if you overtighten the mounting screws, you will see a warp in the trim piece. If you see this, just back the screw off a bit and the piece will straighten out. Also, the edges of these pieces are sharp, so be careful not to scratch your paint when placing them on your bike. |
| These look really great, especially if you add other side chrome pieces. These are much nicer looking than the standard grey covers. Mine showed up, however, with a piece of foam "weather-stripping" missing from the interior edge of the left unit. I bought a roll of weather-stripping at Home Depot for a couple bucks and installed it myself because there is no way to order the piece from the factory in China. Otherwise, 5 stars for a beautiful product and I highly recommend these. |
| This is a very nice looking piece and I highly recommend it. That being said, however, the fit is not perfect; the trim piece seems to be a bit wider than the fender tail. I used some strong clamps to hold the edges to the fender hoping the tape would take a good hold. So far, so good. I like the simple design. I wish there were a front fender piece with the same simple straight-line design. |
| Ohhh yeahhh, these look nice. Do a couple test fits before peeling the back off the tape. You should be able to get the top and bottom sections to line up perfectly if you do the test fits first to determine the exact placement of each section. I just took a 1500 mile road trip through the heat of CA, NV, AZ, and UT with the high temps over 108° and the tape held, so there's no way you'll be able to adjust these in your cool garage once you stick them on. I highly recommend these. They look great! |
| Nice. Once you start adding side chrome, you have to add these to carry the chrome towards the rear of the bike. Easy to install. I highly recommend these. |
| Easy to install and they look great. I highly recommend these as a must-have item. |
| I like everything about this: fit, form and function. BUT the LED lights are tooo darn bright at night and distract your attention. Will try covering up with a black sharpie. |
| I've had a SVR in my 84 Aspy for almost 9 years and never has had a problem. I have a lot of lights and audio equipment. I keep it on the tender when not in use for prolong periods of time. And I bought another one just for the heck of it . I am not used to a battery lasting that long |
| I got the product today. Install was straight forward but the appearance after install looks like some backyard mech made it. The form and fit could be much better where the front and rear peice mate. No noticeable heat increase. Hopefully it does what it is intended to do. |
| I lubed mine with spit and pulled carfuly with needle nose. I took a razor and shaved a little off the top and beveled the side were it was smashing the seal.The remote works fine now. |
|
Installed on 2012 ABS GL1800. I'm adding this info for those that have a 2012 and were wondering what will fit. I will review 27 items that I installed on my 2012. The install went perfectly and I prefer this ws over the stock or F4+4 (tried both). Highly recommend. |