Contact Us
|
My install went well after reading the other reviews. I did not have to adjust the exhaust chrome. The pedal does sit more forward in the indention in the exhaust but does not hit. We love being able to mount up and hook up while the bike idles on the stand and then just ride off. That works very well. However we have not been able to back onto the stand with both of us on the bike. I'm not sure if it's bad technique, too much weight or just not as advertised. |
| We looked at different ones and read reviews. We even simulated the position of different ones while the wife sat on the bike. She chose these and loves them. The install was easy, they seem well built, have the best position and they look good. Putting them up and down is easy for her. The only down side is they can get into the back of your legs in stop and go traffic. She is a good girl and puts them up when we are in town. |
| The wife sat on several bikes with different armrests. There were several she liked but we settled on these because of the look and ergonomic issues with others. These look like they belong on the bike and should be standard. The installation is a challenge. There are hidden linkage/brace parts that must open and close with the trunk lid properly. Removing the original pads is work. Instructions are vague. Be certain of location before you drill. |
| It's a little pricey but worth it. It has already paid for itself in saved labor costs. It is very good quality and will provide lots of valuable information. |
| This is one of those things you hope you never need. If the other reviews are right this is a good preventive measure and if the ground effects work a big plus. The stainless steel was perfect and installation is easy on a lift, not so easy on the ground. The front piece required a little tweaking. The louvers should prevent any heat buildup. |
| This is "in my opinion" the nicest looking rack available. The chrome on mine was good on both sides but I had to reattach the rubber piece right out of the box. I like the look close to the spoiler so I did not use the risers. I did use the chrome/rubber star washers to spread the load. Installation is not that bad but there is no going back. Take your time, use lots of masking tape, measure till your 110% satified. Pay attention to the instructions about drill angle. |
| These are great. I am 5'6" and straight back, as pictured, is perfect for me. They look good, have infinite adjustability, and are holding up well. Installation was not bad at all. Instructions were typical Kuryakyn. |
| Kuryakyn makes this great little adaptor harness to multiply the number of female connectors to plug and play "other Kuryakyn accessories". PROBLEM! Kuryakyn in it's infinite wisdom provides no male connectors to plug into the 4 females. If the Kuryakyn part, or any other LED part you buy does not include the male connector, like my Kuryakyn license frame, you can cannibalize this harness, as I did, for the 1 male connector. Kuryakyn makes a lot of great items that I have purchased over the years but this not the first time I've experienced issues and attitude. I won't say that I will not buy their products again but I will exhaust the other possiblites first. |
| I installed the F4 plus 4 on my 2012 Wing.. So after using regular cleaner I decide to take the plunge and get the cleaner. It's good and less streaks. Better then windex. Like one reviewer said "if you are gonna spend that kinda money on a windshield why not make sure you protect it". Should deff not cost this much but.. Considering what we spend on our bikes it's just a drop in the bucket!! |
| Installed on 2012 ABS. When I first saw these I was like what's the point.. But now that I have them installed I see what it is. Get them they make a world of difference!! Don't over tighten they are plastic!! |
| Installed on my 2012 ABS. First let me say the reviews were great Thank You! And Thank you Bob for your response to my e-mail be and ride safe....But after looking at the PDF of the instructions I realized this was more then I could do in my garage. So I took it to the dealer and boy am I happy I did. They told me that it took there guy 8 hours to install it on my bike. I was happy that I didn't try it! Of all the money I've spent on this bike(and I'm sure there will be more) this was the best 200 bucks I've spent having this installed. And saved me a lot of stress. It looks good and you can't see it once you take the ball off. It also comes with a master lock that is good quality! All in all great hitch for you 2012 Wing!! |
| Installed these on my 2012 ABS. And went on without a problem, I can tell you this the 3m tape sticks good and fast! Make sure you have it where it is suppose to be before you attach it because there is no moving it once it's stuck on.. I used these with the Honda Line Rotor Covers and it looks very very good! These lights are very bright and can be seen during the day. |