Contact Us
|
Did a little shaping to part by hand (Bending) for good contact across the entire radio. Cleaned with alcohol and installed. Look great... Also purchased knobs to finish off |
| Installed Gauge on right side panel then wire into my Aux. Fuse Block. Been in service for about 2 years and works flawlessly. Nice looking and easy to read day or night. |
|
If you like comfort on short or long rides you'll love this backrest! Installation is fairly easy, about 2 hours and seat is back on Wing. Great Product and would buy again... |
| Replace The CHEAP Honda line with this when I did a flush and refill of pre-loader system... A+ Quality for this line... |
| Got it Mounted it and like it!!! Easy install and keeps my coffee hot for about 60 to 75 minutes, usually its gone before it would have the chance to cool off. As far as it being in my way...No complaints to talk of. Chrome finish is good and mug sits in holder snuggly. |
|
Living in Southern California means dealing with sinking kickstands when they are on hot asphalt. This is just for bicycles; add the 900+ pounds of a Honda Gold Wing on top of the kickstands pinhead foot and well... I got tired of listening to the sucking sound every time I pried the bike loose from the liquid surface... UGH! This solves the problem of the "quicksand" asphalt as well as pulling off onto shoulders which are gravel. I do check the set screw every so often to insure it has not worked its way loose due to the hours of use and miles behind those hours. I recommend this - highly recommend this - product. |
|
This is without doubt, the most useful purchase I have ever made. I just picked up my 06 Wing from a Honda Dealer after having the latest brake recall done. I had new tyres fitted at the same time....went for a ride and noticed a scraping sound as I was parking in the garage. It turned out to be the rotor scraping on the left hand front outer caliper. So I removed the left caliper etc.from the bike and put the relevant DVD in the computer, and in no time had all the information that I needed to fix it properly. I am astounded that they didn't check the gap between the rotor and caliper housing at the shop. You can save a fortune by having this set of videos. Steiny from downunder |
| As always, nice quality from Kury. However I did not buy it for a cup holder thou. This makes a fantastic place to mount a full sized 2" voltmeter gauge. I also added some small pulls to the rubber inserts so that they are easy to pull open. You will need a 3.5"OD X 2"ID piece of thin strong metal (I used the lid from a 5 gal bucket) and paint to your liking. |
| This is not a simple install. Instructions completely suck! On my 2016, there is a piece of the shroud on both sides that get in the way of holes. The only way to install is to cut it. Even after doing that, I couldn't get it on. I gave up because I was so angry. I'm out $90 and I probably can't return it because I cut it. Freaking awesome. Hope Wingstuff gives me my money back in good faith. |
| Installed the radio chrome panel accent cover and then these little jewels... Love the look over stock and install is a snap... Fit is very good as is the chrome finish !!! |
| Big difference from stock...They look Great, Good Chrome Finish and Great Fit on Wing... Love the New Bling of these Covers. Would Recommend... |
| Purchase my wing with 10,000 miles on the clock. the original owner put on chrome moldings and after 5 years the finish started looking less than what I'd like to see. Purchased and installed these and the look is great! Easy Install and a great fit. |