Contact Us
| Super easy install and really shows off the back of the F6B day or night. |
| Excellent packaging and instructions. Top shelf product. Took about an hour to install and tune-in. Really completes the look of any '12 Gl1800 or F6B. |
| I found that this converter does not work properly with trailers with led lights. The signal light will not not flash when the brake lights are on. |
|
Klock Werks was very fare with me. I pay shipping & restock fee. I replaced the 16" with the 14" and it works better then the stock shield, Looks nice. Only negative is full turn left and the cables hit a little. So for that 4 stars. As far as WingStuff -1 star on this one. I called them about my shield being scratched by the fender extender that some fool put in the box with the shield. They said it could not of scratched the shield since both had factory packaging. That was not true since they cut the package that the fender extender came in and folded it over. That edge is what scratched the shield while bouncing its way to my house. Also I was told "Did you remove the plastic cover off the shield?" I said yes since I would not have seen the scratch had I left it on. Reason #2 that I own it was I took the plastic sheeting off. So at this point I can say I will not buy a shield from my old buddy Rick again. PS I have known Rick since before he Started wingstuff & will keep supporting him but no more Shields. $100 lesson learned |
| The chrome finish in excellent and all of the parts fit well. These are my second set, the first set was on my last Wing. Over the course of nearly 8 years in the rain of western Washington state, there was very little rust and the chrome finish was holding up very well. I will see how these do over the course of this coming year. |
|
I cut slots in the rear side holes and it made rear panel installation very easy. Without doing that, I am sure it would have went much harder. The front panel looks absolutely hideous. It nowhere near follows the contours of the bike. Unbelievable they would sell something that fits so poorly. I will keep this on as it will help protect my bike... but if I see another brand that doesn't look so bad.. I'll likely replace it. Notice they never show a picture from the front! |
| Didn't like the extra heat after installing it. Removed it the next day. Will be looking for a had crafted part to only cover the plastic coolant tank which I saw some place in a Goldwing blog. |
| Easy to install. Works as advertised, the seat still does not get as hot as the heated seats in my car, but it is comfortably warm and noticeably warmer than the stock configuration. |
| real tight, had to use 2' crow bar to get bolts started. What a pain, 4 hrs later it is finally done. Now for the wiring. |
| First I was very satisfied and it looked great on the bike but less than 50 hours riding the second segment in right side of the LED is of...now it looks foolish, and it dos not seems to be possible to repair...or? |
| Careful removing stock vents. Use small plastic or cardboard to protect your paint as you use a very thin narrow screwdriver to gently pry the pins from each side. Notice the 2 locations on the side of the new ones and insert screwdriver there. Gently pull one side and repeat. They simply snap back in. NOTICE there a Left and Right. Notice the L and R on the part number so you don't mix or force it. Little pricy for the value, but if chrome really pops with your bike/trike color, then these really stand out. |
| If you like chrome and have several pieces around the handles, then this is a no brainer. Very simple and quick to install. Clean, peel adhesive back and apply. Very glossy chrome. Fits well. You will really notice the difference. |