The mufflers sound good once installed, but the box did not include the clamps. Two bothers sent clamps to me but one was the wrong size. The real issues is the tabs on the right muffler are off on the alignment. It is so far off the heat shield looks like the bike has been laid down on the right side while the left side is nice and tight. |
Not a bad rack. I like that the mounting kit has 2 mounting washers per bolt that is machined with a bevel that allows you to twist the washer to match the angle of the trunk lid. This helps prevent cracking of the trunk lid and gives a nice clean mounting. I have no regrets. |
Excellent quality, looks great and very functional. Instructions were poor. Tiny pictures instead of a diagram, Watch a YouTube video, much clearer and shows the removal of the fog lamp cover and engine cover. |
Got the filter very quickly, thanks again Wingstuff! |
These are beautiful but , they don't fit very good , they seem to not have enough bend to form to the contour, I even put a lot of double sided gorilla tape.I m going to have to put screws in them. |
I'm unable to remove the back top cover. I tugged and pushed and thought I was going to wreck it. I called the Big Bike Part manufacturer & they confirmed I was doing it correctly & suggested that even if I broke the tabs in the removal process that were are lots of points of attachment. At that point I was prepared to lift and twist it off but I couldn't pull the front of it over the passenger hand rails. I gave up & reassembled it & put it back in the shipping box. |
Fits well, easy instal, should do the job. I would not pay extra for the painted version though. The paint started peeling just from handling during the install. |
easy to installed, after 400 mile working great. Don't even notice there. |
I could not get this wrench to fit in the small space on my 21 GW tour. |
Good OEM quality. Paired on first attempt and has been working as intended since then. Why Honda did not provide a 2nd with the original 6th gen bikes is a mystery. |
Must have for a plug and play install with later GL1800s AND the F6B. Plug wires were not crimped enough and I had to repair. |
Plug and play for the most part and it DOES FIT the F6B. I have a 2013 Deluxe with heated grips and it fits in nicely. I wish the gauge color (red) matched the dash lights (ice blue) but other than that, really nice unit. They provide a Honda OEM plate with the Honda OEM gauge. You will need the extension cable to reach the left hand side. |