TOP REVIEWED
-
Rubber Baby Buggy Bumpers for GL1800
By Pakit Rak SKU: PRRBBB
- $12.99
-
-
-
Your Bike
Will this fit your bike?
-
172 Member Reviews
1 Star: 16
2 Stars: 10
3 Stars: 8
4 Stars: 33
5 Stars: 105
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
10.30.2009
5 Stars
Just put them on the other night. Easy install and I didn't break even one of them. I used spit as recommended! They do send an extra just in case. I suggest following their directions for opening & closing the truck (which I believe is also recommended by the manufacturer) to prevent damage to handle release mechanisms. |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
10.28.2009
5 Stars
These are great not noly do they keep the trunk lid and trunk from rubbing. When you open the trunk it pops right up |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
10.26.2009
5 Stars
I wish I had seen these this summer. I am hoping santa will give me a set of these for christmas. |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
10.22.2009
5 Stars
I installed these on my trunk and they work GREAT!!! If you own a GL1800 and want to prevent paint damage when closing your trunk lid, these are a MUST HAVE ITEM. Easy installation and they work wonderful. Highly Recommend!! Frank |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
10.20.2009
5 Stars
There is another lid support system that is really well made and really pricy. It has gotten great reviews, However... it only supports the trunk lid at two places, on the outboard edge of the trunk, leaving a possible load on the lid hinges. This kit is simple, inexpensive and supports the trink lid at all four corners. I have found that when properly installed the bumpers last two or more years with the loads I put on them, "10 pound trunk rack bag". At this price, it is nothing to replace them if needed. The key is proper installation! A great product in my opinion! |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
10.17.2009
5 Stars
10-STARS!!! This is THE single most important item to put on your GL1800 as soon as you get it. PERIOD! Even the DEALER recommended it. Comes with a paper template that you scotch tape on the top of the trunk lips and drill 4 - 1/4 inch holes. Easy to install, works like a charm. Remember when closing your trunk lid you face the rear of the trunk and reach over the top of the lid to the passenger backrest cushion and place your left and right hands cupping the top of the cushion and apply a firm snap motion to close the lid. It's going to be very tight the first few times but it will ease up after a few hot days. The time to put these on is as soon as you get the bike. The trunk paint rubbing starts immediately without these. I am so glad that wingstuff finally is carrying these! A+++ For total paint protection, I also recommend some of the small 3/8 inch diameter felt disks you can buy at walmart or lowes and place one disk next to each of the 6 protruding tabs on each side of the trunk top edge plus two disks on the rear area next to the tabs there. Also, the area right on each corner up by the trunk lights highest points can just barely rub there as well. I placed some velcro (soft side out) there and I've had zero paint rubbing. |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
10.16.2009
5 Stars
This should be put on the goldwing before ride it. If you dont have them on your trunk the lid of the trunk will cut into the bottom. A must have. It wil take about 30 min to put them on. |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
10.15.2009
5 Stars
Have had these installed for over a year & they work great. |