|Really like the look and function but just not crazy about drilling holes in body parts. Also getting lid liner back in proper position was a little trying with wiring making the fit tighter.
|Had this on my 2018 goldwing and the trailer wiring worked well. tried to move it to my 2024 goldwing and found out Honda switched to low voltage in 2021 and there is not enough power to make the blinker relays work. I have not contacted show chrome yet, but wanted to save you the time and money if you have a 2021 or newer goldwing.
|Very easy to install and no more noise or chaffing for the trunk. Well worth it for the price.
|I've been using this F-4 windshield since 2004. I just had to replace it now in 2024. Excellent product.
|This stand was an easy install, and made it easier for me to be able to Put my bike on the stand . Having back issues, This part helped tremendously.
|The flasher works as advertised. It took longer to disassemble the trunk than it did to install the flasher mechanism! I chose to adjust both pots to midrange. I tried it out and my spoiler light flashed for approximately 3-4 seconds. I left it at that and reassembled the trunk. Tickled with the result! It doesn't hurt to add a flashing brake light for added safety!
|They fit, but they needed modifying before they would do so! The problem is "orientation notches" (one square and one half-moon) on the flat plate of the bulb base are ever-so-slightly smaller than the ones on the original bulbs, and hence the bulbs will not seat properly in the fog light housing until the notches are widened/enlarged. I performed this alteration with a dremel and a small sanding wheel and it did not take long. However, this is not what I think of when I order a "direct replacement" part! For this reason, I can only give it 3 stars at the moment. I bought these replacement bulbs to enhance my night time riding. I will report on their effectiveness once I have some miles on them!
|I bought this fog light replacement harness with the H3 55W bulbs in hopes of getting a better night time driving lights and lightening the current load on the fog light switch (I already had to replace it). I found it easy enough to install, but I found the wire that hooks to the battery 12VDC to come up lacking....roughly a foot short! Now I guess this could depend on how and where you decide to run the wire, but unless you wanna strip the bike down to the bare frame to get a direct shot to the battery...it's gonna come up short! No biggie....I just spliced in a piece of 14AWG red wire to extend it, but what would it have hurt to make the 12VDC battery source wire another 12-18 inches long? Just my 2 cents on the harness. Otherwise, the harness was spot on with regards to fog light connections. Not a bad harness, but room for improvement!
|Bright light to see inside your trunk in the darkness. Auto shutoff to prevent battery drain. It does require the purchase and installation of the trunk harness. I would advise to install the luggage rack and brake light at the same time as many of the steps are the same. WingStuff has a video done by Fred Harmon on Youtube that details installing all 4 items at once. With the video, anyone could do the install, just take your time!
|Easy install. Increases rear visibility, and flashing brake lights grab other motorist's attention. A must have if you have the trunk mounted light.