Contact Us
| Needed a new OEM vent and checked with local Honda dealership. Honda wanted $240 for the full vent! Crazy. Found on Wingstuff for $65...approx. Everything I order from Wingstuff is exact fit great products. |
| Easy install. Biggest challenge was adding the sensor into a convenient/accessible place. This strobes the HIGH BEAMS rather than the low beam headlights. Very bright, almost to the point of annoying for drivers. I like them very much, overall. Real attention getter. |
| This is a great product and fits well in the bike. The Tourmaster trunk liners fit perfect when packed. The inside lid has a small zipper compartment inside each to stow small items. I run with one side bag all the time to contain the misc stuff in the truck and I can still fit my helmet in the trunk no problem. The bags could be improved. There is no buckle on the bottom so they wobble a bit when carrying. I knew that when purchased it so not worth downgrading the review. Other then that no issues. One trick is that it’s easier to load them into the trunk one at a time (sides first then center bag) instead of all buckled together. Fits great and contains all the trunk items neatly. Highly recommend |
| I’m on my second light. The sticky stuff that holds it to the trunk lid wasn’t holding on the first one and the wire harness wasn’t long enough to reach the isolation block. A new one was sent and I called big bike parts for advice. I did everything they said like bending in the middle so it would fit the contour better. It was fine when I first installed it. I haven’t been for a ride since. The hot weather here in CA has caused the ends to start lifting again. Also the harness on the new one was long enough to reach the isolation box. I’m past the point of going to something else. The hole is drilled. I don’t understand why they just don’t make it with a little more bend. |
| This is a great product, really gets the attention of the drivers behind you. Motor officers have similar lights link to their brakes that tie into their emergency lights. Extremely helpful as an attention getter. |
| These fit my 2006 Goldwing perfectly! |
| They fit my 2006 Goldwing perfectly! |
| Fit my 2006 Goldwing perfectly! |
| Instalked grip per instruction with exrt cleaning on factory grip. I had this grip beck off while trying to merge into traffic, by it backing off I had no throttle. Close call#1Close Call#2 left grip backed off in the twisty turn and almost straightened out the turn. Stopped then an remover grips. Oh they slide right off we no tools. Very poor design!!!Be safe if your riding them, the adhesive will not hold grip in place |
| If you set the fitment (Your Bike: GL1800 1st Gen) this part will not fit your side stand. It is specific to GL1800s 2017 and up as seen in small print under description.. The set screw will just come out the backside and fall our without touching any metal. I think it best if you call in and order by phone as I will do tomorrow. I hope this gets fixed soon. Bill SteinSan Antonio, TX |
| Cousin recently bought & installed these highway pegs. We took a short ride for the weekend on the way back the peg fell off the bracket(this is assembled by Rivco). He calls Rivco they say sorry not under warranty!!! What?? They are brand new assembled at RIVCO factory and the peg comes off. Thank goodness his foot wasn't on it when it happened could have been fatal. I have purchased RIVCO products in the past but after this- no thank you! |
| Tried a couple of other brands before I settled in with these Bridgestones. I have gone through 5 sets averaging about 9,000 per rear and about 15,000-17,000 on the front. The Wing loves the twisties and these tires have performed really well over the years. Wet weather has not shown any slippage but I generally cut my speed a little to compensate. Drove home to Alabama 1 year from Pennsylvania and the treads were showing by the time I got home in a couple of areas (can you say stupid). Anyway, these tires have never let me down---highly recommend! By the way, I usually ride with wife and a FULL load for which I add a couple of LBS of air. |