Contact Us
| Easy to install and an excellent investment in your safety! |
| I ordered these to keep in the Goldwing just in case I need them. I don’t want to be somewhere and need a spare if one goes bad. |
| I'm a disappointed with this protect . i received the the screen and it was broken on the lower edge, and if there is any wind the screen starts shaking, i reported the issue to wing staff and nothing happened, it is well over priced for what it is. .The F4 is very badly finished around the edges, i don't recommend anyone to buy this item, |
| easy to install and a nice accent for the front of the bike. looks great |
| Looks great as an add on to the front twin rail floorboards |
| The lights look great on the bike. They are relitively easy to install. The instructions are garbage. Don't use them. They mention removing the side mirrors. Don't do that, it is not necessary. Watch Fred's video on installing the buttons on the center console. It will save you hours of work. With that the job took me about 1 1/2 hours to install. I also put in the homelink buttons and the steering safety pin from Traxxion Dynamics while I had the console out. |
| These grab handles are much better than the original ones that come on the 2018. They are bigger and give your passenger something to grab when they need to. It also doubles as a tie down which I'm sure wasn't part of the original design but it works. They are a must have |
| Bought the Honda rack mainly to install a higher brake light for visibility and the occasional small duffel bag. The part is definitely up to Honda standards with a nice layer of chrome. The rack itself is much beefier than the 5 lb limit would suggest. The limiting factor is it is supported by the plastic inner trunk. Install is pretty involved, but directions are clear and step by step. It does require drilling holes in both the inner trunk and outer trunk, but drilling locations are molded into the bottom of the Honda trunk plastics. |
| I primarily purchased this trunk rack to be able to mount Pathfinder High Mount Sequential LED Brake Running Lights, and not for the purpose of using it as a trunk rack. It is serving my intended purpose very well. |
| The problem is the left blinker wouldn't work, I have a 2013 F6B and no matter what I did. Tried switching the lights couldnt get the left side to work properly. I put a new set of stock lights back on and they work fine. Wish I knew what it could be. Regards, Tom |
| fits well and looks good. Very thick carpet. like the looks of it |
| Easy installation. I have the Hondaline fog lights so there were two extra bolts to remove on each side during the installation. Will make trailering the bike very simple for tying it down.Would definitely recommend to anyone that needs to trailer their Wing. |