Contact Us
| everything fit just right. Instructions were clean and to the point. And best of all, it looks good. |
| I have only quickly looked through some discs which I found to be a bit lacking in production quality although the information is good. |
| The screens fit perfect and are very necessary to ensure a rodent free air filter system. |
| Very easy to install. I permanently installed daylight sensor on left top plastic panel under left handlebar. I drilled the hole for the sensor and passed a fish tape (actually a large cable tie with the end cut off) from hole up towards the headlight - took a couple of tries but very easy to do and much simpler than removing panels to mount the daylight sensor. Really easy to do. Cruiseman video shows permanently mounting the daylight sensor on right side and instructing on the removal of panels makes a much bigger deal out of it than necessary. Sensor Works great and you will definitely get driver's attention. I wouldn't want on all the time during daytime, but for high traffic areas and intersections in my opinion. Might be too distracting otherwise. You might get mistaken for a funeral procession motorcycle, but definitely makes you more visible and as they say "better to be seen than viewed!" |
| The first side took me 45 minutes, the second side took 15 minutes. The pictures on the instructions could be better and could really use a quick video. But works great and really directs and blocks the wind very well. Glad to have them on my bike. Worth the money and quality product. |
| I have a CSC Escapade LE trailer. The cover is a perfect fit. Easy to put on and remove. Surprised how easy it was to pack back into the storage bag. Would not hesitate to recommend. |
| It would not fit on the bike properly and made the passenger uncomfortable so I returned it |
| Quick and easy installation, complements the rear lights well and increases overall visibility. |
| First Goldwing and wanted to protect the under carriage of the bike. PITA to try to install and never got the last acorn nut on after wrestling with it for over an hour. Could not get the body panel out far enough but I think it will suffice with the other 3 nuts holding it in place. Do not hear any vibration or rattles on my initial trial run but will probably remove and cut a larger hole in the pan and body panel later. Also don't know if the PO had repositioned the drain lines under the bike but they did not align with the hole in the pan at all. Hope it serves it's purpose.... |
| Simple bling!!! Looks great and was easy to install. |
| I purchased two of these for my gl1800 and they fit perfectly and are very magnetic. Seem to be a great quality product. I appreciate the great website and products that y’all offer. |
| Easy to install. They center my trunk lid and removed all the squeaking it did when riding. Recommend 100%. |
