Contact Us
| Beautiful replacement OEM. Easy installation, highly recommended. |
| Original parts from honda and they helpful for side ways at night to the ground and saddlebags |
| many recommendation and when i try them so far they are the best and smooth with curves |
| I purchased this as a Christmas gift early December. I was advised that there was an issue with the batch they received , they were waiting for the new shipment and it was not shipped until December 20th. I was shocked to receive it on December 23rd! Fantastic customer service. I am thoroughly impressed with the quality and clarity of the windshield. It actually looks better than the stock windshield. The templates for the rubber bumpers are incorrect, but it is easy to see where they go. I can’t wait for riding season! |
| What can I say. The oil was as advertised and arrived as promised. |
| This drink holder looks good, has great quality, and works effectively. Easy to install as well. |
| This is a very nice shirt and well made. It does run a little small so if your are a large you might want an XL. Heavy shirt not light. |
| These items are such a nice SMALL accent piece. These are items to take your time , pre-fit and pre-Fit AGAIN. They look really GREAT. |
| It's a solid mount for your phone. The perch mount does not allow you to fully get the phone out of the way of your right hand side controls and does not allow you to position the phone where I really want it for maximum viewing. All that said, not sure there are any better alternatives. |
| I purchase the Goldstrike Ciro left side cup holder (for 2018+ goldwings) and I like it. Easy to install and works well. You are able to swing the ball to the front of the bike to get the cup holder out of the way of your controls. The hardest part is making sure the tab of the perch mount goes into the Honda slot and you don't crush your wires. It's a little finicky. Takes all of 15 minutes requires a Phillips head screw driver. |
| Had to bend the supplied brackets to get it to fit right, even though supposedly this problem has been fixed. Doesn't fit exactly flush with the bottom of the forward cowling, unless maybe I bend the brackets again some more, which I'm not going to do. But anyway it's basically almost invisible from a standing position. I suppose it will do the job if necessary. A bit thin, but that's a trade off for decreased weight as opposed to the Traxxion skid plate. Note: I was able to get the right side bracket on without removing any plastic, but had to take off some of the trim to rethread the engine guard bolt on the left side. But maybe someone might have skinnier fingers than I do. |