Contact Us
| Makes the bike look great. Takes some doing to splice the wires together. After 55,000 miles had to redo wires once. A difference system for wire installation would be nice. But still the best looking item on the bike!!!! |
| Helps protect the bike and looks great! Highly recommend! |
| Anything you put in the lid of an 1800 will make it hard if not impossible to store your full face helmets in there. BEWARE! |
| Adds a great look to lights, worth the expense, take your time when installing and make sure surfaces are clean and dry before installing. |
| Works great in the panniers, forget about putting ANY type of organiser in the trunk if you still want to put 1 or 2 full face helmets in it. There just isn't the room! |
| Very pratical way of tidting up your panniers and trunk. If your using a full face helmet it will make it just that little bit tighter to get them in the trunk. a flaw in the design of the 1800 in my opinion, wish the trunk was that little bit bigger. |
| Tarts up this area no end, well worth the investment, be careful what you clean it with as can be easily scratched if your not careful. |
| Take your time when fitting this unit, the tabs along the inside edge of the fairing can be difficult, once on it looks great. I put some clear film on over the paint where it maight get rubbed by the underside of the Bra (Nose Mask) with this part fitted, you cannot install GL1800 Accessory LED Windshield Light as the clip that holds the front of the mask in place gets in the way. |
| Very nice peice of bling, be patient in the fitting of this piece. A little time spent gentley pre shaping it before finaly sticking it on will be time well spent. Be gentle whilst bending as you could damage the chrome if your too forceful, only a little bit of final pre bending is needed to insure a great fit. |
| Simple and effective way to clam up the stereo control area, not much more can be said on these. |
| Makes riding your wing a lot more comfortable, stops fatigue which happens with smaller diameter grips. The use of a g clamp to squeeze the two halfs together will make installation a lot easier, slide the rubber parts that extrude through the grips into postion before clamping them together, a little tedious but well worth the effort. First generations of these grips had the rubber in two halfs which were a nighmare, this single peice sleeve design works great. |
| Easy install, adds just the right amount of crome. |