Contact Us
| Simple to install and greatly help in deflecting the bugs and debris from rear fenders. Only fault is that the engine guard clamps are impossible to fuly tighten, you must add tape to get a firm hold. |
|
These work, but if you want them to work right you have to cut 1/8" off the top of them. They are just too tall. If you cut them to 3/8" tall, they work as they should. After cutting- 1. The gap is maintained around the trunk lid. 2. No more rattles and paint damage. 3. The trunk opens and closes properly. (Even with the remote.) Cut them. You'll be pleased. |
| easy install, perform very well. THE instructions say ot tighten 1/4 past finger tight, but I find that misleading & under torqued, or else the wings will flap in the breeze. Tighten until 'firm' for positioning the wing. Then ride at 50-60 MPH & see if they will stay in the 'neutral' position & not be forced open or closed. You may need to tighten further, but incrementally. |
| performs as advertised, and like others, would like to see the clamps fit better around the guard, but they seem to hold up well. Wind on lower legs is signficantly reduced. |
| Easy install great leg wind protection and less engine heat. I noticed it a lot the one time I had shorts on. The instruction said the small hole near the inside is from manufacturing and not used BUT with a small tie strape through the hole and around the engine guard it makes for a tighter fit. |
| Vary easy to install and they do a great job of blocking the wind from you and your hands plus adjust to allow more wind if needed. I will enjoy these even more with the colder weather. |
| I added this and a flashing strobe light to my tag and instead of splicing into the wire harness I purchased the trailer light plug and play harness for less than 35.00. A clean install and it uses the battery and its own fuse to protect the bikes electrical system. This a good product bright brake light and noticable running light. |
| I was able to install in 10 min be sure to use locktite I also used a small heater hose split in the middle slid over the front end peace to stop just inside crowl prevents ratle noise. I think this is a must product. |
|
4 stars because the instructions suck. The product is tops! These shims move the bars up 1 1/2" at the grips, and relieves the strain that causes the pain between my shoulders, and my upper back. It is now easier to keep my posture correct when doing tight low-speed maneuvers, making them easier and more accurate. Good product at a good price! |
| I brought this just in case! The US 2012 Wing does not come with a tool kit anymore. So I got this one in the hopes of never using but having it incase I do..Tools seem to be of good quaility! Bag that holds them is ok! |
| Installed on my 2012 Wing! Very easy to install. Just to be on the safe side I put a little smear of crazy glue on edges just to make sure they stay down.. Looks very good! |
| Installed on my 2012 Wing! No problem installing peel and stick. And looks good.. |