Contact Us
| Nicely designed chrome extender and looks great. However, beware of speed bumps, it can scrape. I replaced the previous extender after cracking it near the right bolt. Got to be more careful, thus 4 Stars. |
| This is one of the best investments for my 02Goldwing, this product was not only easy to install but took away any and all shaking of the front end of the bike, yes you can hear them when moving slow, almost sounds like the break pads against the rotors when new, but turn up the radio and get up to speed and it is as smooth as the ride should be, just remember to tell the bike shops when you have new tires put on, so they don't waist time putting on weights, I still have some cupping of the tires, but not as much as before I installed them. |
|
Ive grown up around Goldwings & recently purchased my first one. I never really liked the highway pegs that just hang out there in the open. As soon as I saw the pegs by RIVCO, I had to have them. They bolt on in 5 minutes, & no special tools/skills to install. If you are considering, please do not let the following discourage you from purchase. One small issue, the pegs are not mounted evenly. They're not that far off, but you can feel a slight difference between the two sides. The right side is mounted farther forward then the left. Yes, I did make sure they were both using the same corresponding holes. When you set the mounting brackets next to each other, you can see the holes on the right bracket is nearly one hole off from the left bracket. Small issue or not, awesome idea, design, easy to use on the go, can't wait to powder coat/paint to match the bike. |
| These wings do every thing that they say they will do. Especially keeping that cold air from running up your pant leg. I have been running this set of wings for 5 years. Somewhere back a couple or three years ago the left side broke and was gone. The whole PLASTIC piece was gone. And I don't even know how it broke. I am trying to decide weather to buy the new Baker unbreakable set of leg wings or just have new ones made up using aluminum with a good baked on paint finish. |
| I have used these floor boards for 5 years and a few thousand miles and they have been great. I can be riding down the street and if I need to stretch/stand without having to stop the bike, I can stand up on the bike with these floorboards and be safe without thinking that my feet are going to slip off. It took me a few runs to get use to back shifting but it was worth the learning. |
| I got this back in 2010 and every time I straddle my machine this cup goes with me. Even if it is a short trip around town. I have to have my coffee. Most of the time I use it for hot coffee but sometimes I have used it for a cold Frappuccino. And it does a great job of keeping things hot or cold. I have used this cup for a few thousand miles and it is still like new. Just remember, when your putting the cap on the cup either put your finger over the end of the straw or put that little cap on the end of the straw or the coffee will press up thru the straw and splash all over you if you don't cover the end of the straw |
| This bag fit perfect on the back rack on the trunk. My daughter and I have taken a few of the 2 to 3 day trips and this bag is a life saver. Along with the other storage bags for inside the trunks it kept every thing organized. Have not had to use it in bad weather but for the last 5 years it is still like new |
| Looks as good as the picture, the only problem I had was replacing the left and right side fairing molding. My recommendation is making the tabs that fit into the fairing molding a little bit smaller so when replacing the molding you don't break the clips on the molding strip or you will be ordering the chrome fairing molding like I am getting ready to do. The nose mask really makes the bike look good certainly not difficult to put on. |
| Bought it back on 06/12/2014. Works good, follow directions and installs easy. Better yet now I have a way to charge my phone or other devices. I bought a USB charger to plug into this. Great product and factory quality. |
|
I see what has been said about the seal around lens being kinda hard. I found however its kinda like a memory foam in which if you start smashing the foam it will take just a little bit before it returns to its former shape.. So, I found that when I smashed the foam around the lens in circles about 5x you will then have enough time to install the lens without much problem before it returns to its shape.If your to slow then you might have to do it again but, really helps out on installation. Ed |
|
Once installed the unit looks and functions great. Some things you should know. The recommended wiring harness is made fairly obvious and is easy to install. However they are selling you the hitch under the 1st gen GL1800 section so they should tell you that there is an other part you will need to convert the 5 wire goldwing/hitch harness into a 4 wire system on the trailer. You need to order the Kuryakin 7675 converter or wire your own with diodes. |
| It arrived sooner than I expected. Installation was every easy (thanks to YouTube). I highly recommend this windshield. |