Find stuff for your GoldWing by model and year

Find Stuff for your goldwing

Your Bike:
(also showing 'universal fit' items)
Honda Goldwing Motorcycle

WingStuff Community

The world's most active GoldWing community. Seriously.

ITEM: WS187416

04.20.2016
KLM
After reading numerous reviews I decided to take the new belly pan to a machine shop to have vertical grooves cut. I was glad that I did. Even with that it wasn't real easy but I know much easier than if I had not done it.I took pictures but there is not a way to post them here. I had the shop cut vertical grooves in the middle of the horizontal slots so I could just loosen the bolts slide the pan into place. Then I slid it forward and tightened down the bolt caps.I did split some heat proof tubing & applied it to the front piece just to eliminate the chance for rattling. I have not used it on the road yet. If any issues I will re-visit this "review". Best to all the Riders out there.
Was this helpful?

ITEM: HO08F85MCA100L

04.20.2016
I have had several people inquire about this emblem, commenting how it finishes the front fender. It looks like something that should have been original on the bike.
Was this helpful?

VStream Quantum Hard Coated Windshield for GL1800
ITEM CODE: PG24215

04.20.2016
I replaced my stock 2004 very scratched shield with the VStream this week. I like the look on the bike. It gives it a more sporty look. I have only rode 100 miles or so. I can't say that I notice a big difference about the wind and actually the wind from the sides seems worse. I'm 5'9 and the vent view/ placement problem I have not noticed. HOWEVER the windshield is optically strange. It distorts around the vent and some at the sides. Below the vent you get a Star Trek warp speed look. I'm a bit bothered but trying to get used to it. My stock vent fit fine but the vent is a pain in the butt anyway. It is thicker and fights being bent around the mounting points. Closing the windshield locks are scary tight. I always run it full up so its not a problem for me. One of the main problems that I give it a 3 Star rating is the fit of the rubber grommet from the fairing. It just don't fit well at all. The sharp curves of the shield leave big gaps. I'm posting pictures of this on my photos . Bottom line is I'm not sold on it and may call Wingstuff about a return. I'll update soon.
Was this helpful?

LED Step Light w/Chrome or Black Housing
ITEM CODE: PG02857

04.19.2016
Are these lights mounted with 2 way adhesive tape?
Was this helpful?

Fog Light Upgrade Harness
ITEM CODE: PG32594

04.18.2016
Install but wired to my Aux Fuse block. Works great with no problems...
Another Great Product by EC
Was this helpful?

Chrome Key Plate Accent for GL1800
ITEM CODE: BB52759,   SKU: BB52759

04.18.2016
All I can say is 2 minutes for install and it helps to dress up the dash area on Wing.
Was this helpful?

Chrome Radio Panel Accent for GL1800
ITEM CODE: BB52696,   SKU: BB52696

04.18.2016
Did a little shaping to part by hand (Bending) for good contact across the entire radio. Cleaned with alcohol and installed. Look great...
Also purchased knobs to finish off
Was this helpful?

ITEM: HO37453ZW5000ZA

04.18.2016
Installed Gauge on right side panel then wire into my Aux. Fuse Block. Been in service for about 2 years and works flawlessly. Nice looking and easy to read day or night.
Was this helpful?

Utopia Driver Backrest for GL1800 2001-2017
ITEM CODE: UT18MC12,   SKU: UT18MC12

04.18.2016
If you like comfort on short or long rides you'll love this backrest! Installation is fairly easy, about 2 hours and seat is back on Wing.
Great Product and would buy again...
Was this helpful?

Rear Shock Hydraulic Pre-Loader Line
ITEM CODE: WS18LINE,   SKU: WS18LINE

04.18.2016
Replace The CHEAP Honda line with this when I did a flush and refill of pre-loader system... A+ Quality for this line...
Was this helpful?

Driver Stainless Drink Holder w/Chrome Mnt
ITEM CODE: KU1463,   SKU: KU1463

04.18.2016
Got it Mounted it and like it!!! Easy install and keeps my coffee hot for about 60 to 75 minutes, usually its gone before it would have the chance to cool off. As far as it being in my way...No complaints to talk of. Chrome finish is good and mug sits in holder snuggly.
Was this helpful?

Black Anodized Sidestand Pad
ITEM CODE: RIGL18013,   SKU: RIGL18013

04.18.2016
Living in Southern California means dealing with sinking kickstands when they are on hot asphalt. This is just for bicycles; add the 900+ pounds of a Honda Gold Wing on top of the kickstands pinhead foot and well... I got tired of listening to the sucking sound every time I pried the bike loose from the liquid surface... UGH!

This solves the problem of the "quicksand" asphalt as well as pulling off onto shoulders which are gravel. I do check the set screw every so often to insure it has not worked its way loose due to the hours of use and miles behind those hours.

I recommend this - highly recommend this - product.
Was this helpful?

29855 Reviews Found

| 1073 |