Contact Us
| I have had several people inquire about this emblem, commenting how it finishes the front fender. It looks like something that should have been original on the bike. |
| I replaced my stock 2004 very scratched shield with the VStream this week. I like the look on the bike. It gives it a more sporty look. I have only rode 100 miles or so. I can't say that I notice a big difference about the wind and actually the wind from the sides seems worse. I'm 5'9 and the vent view/ placement problem I have not noticed. HOWEVER the windshield is optically strange. It distorts around the vent and some at the sides. Below the vent you get a Star Trek warp speed look. I'm a bit bothered but trying to get used to it. My stock vent fit fine but the vent is a pain in the butt anyway. It is thicker and fights being bent around the mounting points. Closing the windshield locks are scary tight. I always run it full up so its not a problem for me. One of the main problems that I give it a 3 Star rating is the fit of the rubber grommet from the fairing. It just don't fit well at all. The sharp curves of the shield leave big gaps. I'm posting pictures of this on my photos . Bottom line is I'm not sold on it and may call Wingstuff about a return. I'll update soon. |
| Are these lights mounted with 2 way adhesive tape? |
|
Install but wired to my Aux Fuse block. Works great with no problems... Another Great Product by EC |
| All I can say is 2 minutes for install and it helps to dress up the dash area on Wing. |
|
Did a little shaping to part by hand (Bending) for good contact across the entire radio. Cleaned with alcohol and installed. Look great... Also purchased knobs to finish off |
| Installed Gauge on right side panel then wire into my Aux. Fuse Block. Been in service for about 2 years and works flawlessly. Nice looking and easy to read day or night. |
|
If you like comfort on short or long rides you'll love this backrest! Installation is fairly easy, about 2 hours and seat is back on Wing. Great Product and would buy again... |
| Replace The CHEAP Honda line with this when I did a flush and refill of pre-loader system... A+ Quality for this line... |
| Got it Mounted it and like it!!! Easy install and keeps my coffee hot for about 60 to 75 minutes, usually its gone before it would have the chance to cool off. As far as it being in my way...No complaints to talk of. Chrome finish is good and mug sits in holder snuggly. |
|
Living in Southern California means dealing with sinking kickstands when they are on hot asphalt. This is just for bicycles; add the 900+ pounds of a Honda Gold Wing on top of the kickstands pinhead foot and well... I got tired of listening to the sucking sound every time I pried the bike loose from the liquid surface... UGH! This solves the problem of the "quicksand" asphalt as well as pulling off onto shoulders which are gravel. I do check the set screw every so often to insure it has not worked its way loose due to the hours of use and miles behind those hours. I recommend this - highly recommend this - product. |
|
This is without doubt, the most useful purchase I have ever made. I just picked up my 06 Wing from a Honda Dealer after having the latest brake recall done. I had new tyres fitted at the same time....went for a ride and noticed a scraping sound as I was parking in the garage. It turned out to be the rotor scraping on the left hand front outer caliper. So I removed the left caliper etc.from the bike and put the relevant DVD in the computer, and in no time had all the information that I needed to fix it properly. I am astounded that they didn't check the gap between the rotor and caliper housing at the shop. You can save a fortune by having this set of videos. Steiny from downunder |