Contact Us
|
I knew this mirror accents are attractive since my '04 Wing has already and I love them! I was just worried about if this fits for my '17 Wing. Yes, fits perfectly and the adhesive tape works great too. |
|
I order this for my '17 Wing to change from dull gray OEM cover. Just few seconds installation and looks amazing!! It worth to pay for the "Gold Wing Logo." I will order another one for my '04 Wing. |
| I just installed this light and really like how bright it is! No instructions came with the lights, but I was able to find a video on line to help with the assembly. I am giving it 3 stars because when you turn on the left turn signal the running light feature stays on, but when you turn on the right turn signal the running light feature goes out. |
| Easy to install and really dresses up the front of the trike |
|
I bought this for my 2017 Wing. The installation is the simplest: just snap-in. I really like this design that I can check the engine oil without removing the cover!! Great idea!!! Off course, it look amazing too. |
| noticed a huge improvement in the suspension after adding this fork brace. Its probably the best investment you can do for your front end without a question. |
| These are sharp looking and a very nice fit where they meet the stock mufflers. My only gripe is on the right right it took some custom fitting by me to make the rear edge level with the ground. ( Im picky ) I still give this 5 stars. Easy to install. |
| Installed on right side. Simple install. Nice and bright day or night. Easy to read. |
| Replaced the spring along with the oil line. I was surprised by what it takes to get to this spring. Before while riding two up I'd have to preload set at 20 and would bottom out. Wife loves how our 03 Wing rides now. Now, even with the preload set at 0 we have yet to bottom out. I'm sure that will change in time as the spring does settle some. Also changed the fork springs as well. The Wing does set a little higher now, almost to the point of having to lengthen the kickstand. |
| I don't think I've ever been so surprised. So much better then the original ball bearings. When removing the old bearings found that they were loose. No need to buy the special Honda socket for the spanner nut. A 1 11/16 inch socket will work for the bottom nut. Then use a punch to lock down the jamb nut. The only bad thing is that they don't include the locking washer with the kit. But, if you are careful you can reuse the old one. WOBBLE IS GONE. |
| One of many upgrades. Follow the manual for a simple install. A big improvement over stock. |
|
Just purchased these for my 2016 GL1800. As stated here, the look is clean and function is great. The offset when mounting is from the engine cylinder spacing one side to the other. The Aero Peg's adjust for this just fine. Their positioning is quite comfortable. I do long rides, these are as nice as my old Markland Hwy foot pads. They flip out easy when riding with the tabs Rivco has on the bottom of each peg. They even have a machined safety notch to break away the peg if it's out in an accident, saving any damage to the engine. American made. Fit and design are spot on. This is a fine product and just a bit more cost than the popular Chinese made clamp on Hwy pegs. Two Thumbs Up! |