Contact Us
| Great protection for the money, I got Two, but neither one has the RED, WHITE, AND BLUE WING ON THE FRONT. |
| I nice addition too break up the front fender. Always check you placement before you attach them. |
| These grips are great! Make sure that you put a drop cloth over the bike and areas where the glue may drip. If the glue drips on the fairing, you can't get it off without ruining the paint/plastic. I am going to have to have a body shop touch-up my mistake with some paint! |
| Super easy to install, can't wait for my wife to try them out. They also look great with the matching front floor boards! |
| Had this set for about 3 years. Loved them till the small pins broke off inside the connection. Lost the mic. only way to replace is buy new upper cord and helmet base attachemnt. I ride in all kinds of weather so figured moisture got in and corroded the pins causing the break. Otherwise great system. Pins also broke on the 3/4 helmet system. |
| Look real good easy install |
| I bought the 20oz driver model. Installation - relatively easy once I saw what the instructions were trying to say. Convenience - very good. Does not obstruct any controls or view of the dash. Easy of use while riding - I mounted mine on the right side so I could use my left (non-throttle) hand to remove. It's very easy. Comfort - I found the straw just a little too stiff to get under the chin part of my full face helmet. A bit more flexible straw would do better, I think. Would like to have the 34oz as well, but it's not clear if I can buy just the mug, or need to buy the full $49 kit again. |
| Nice looking flag but after 500 miles, the threading has begun to come out. This could be a factory defect since other folks don't seem to be having any trouble. |
| bought this at dealership and had them install it. sure looks good. dealership had trouble finding the right trailer connection. but like the way wires and everything is hidden. |
| Great product but not for me. did not like the way it made you sit straight up. even had the adjustments to the very back hole. wife was uncomfortable on back with this installed. made my back hurt. but very easy to install. |
| Made very well. Much better than the draw string bag I was using before. It has a small slit on the battom so that you can use the hemet bracket adapter through the D-ring and secure it to your helmet lock. I bought two of these. |
| Added these after the luggage rack had already been mounted,It just didn't line up correctly had to use the 1/4 inch drill bit to open up original holes as directions state that still didn't work had to oval holes with drill bit, still would not line up easily and the risers do not mount flush with the with the curvature of the trunk lid.A lot nicer once installed now I have room to clean the trunk lid easier and attach my Kury bag alot easier,They should have been on the luggage rack right from the factory |