Contact Us
| I have many thousands of miles riding. Every couple of years I need to replace them as they fade and get tattered, but they are a great looking flag and considering my extensive riding, they hold up extremely well. |
| I got a free TomTom GPS, but it was made to be used inside a car. Using it's suction cup mount I nearly lost it to the road on a couple of occasions. Made the investment in this mount and I am very happy I did! Holds the device in place, secure as can be. When unmounted the ball-mount stub is barely noticeable. I routed the USB cable down the handle bar along the factory wiring, makes for a very clean setup. |
| Exactly as advertised perfect fitAnd exactly what I needed. Positively will purchase this again |
| If you don't have a second key fob and you lose or break the only one you have. You will have to replace the computer. And that is way more expensive. It is easy to program too. You don't need the shorting adapter either. Just use a paperclip and connect the 2 green wires during the programing. |
| Lots of room. Is the best way to describe this luggage rack bag. Construction is excellent and much larger than I had suspected. Be smart, and do not overload this luggage rack bag. This bag should be used primarily for clothing. I will be making small modifications such as putting additional Velcro straps to secure it to the rack. If you are riding two up, this is a must. |
| These are really nice. Took about 15 minutes to install and adjust. Nice finish and look really good on the wing. |
| I only use these OEM maintenance products on the Goldwing. Shipped fast. |
| Shipped fast with other maintenance products. |
| Only oil I will use on the Goldwing. Shipped fast. |
| When I purchased my Trunk Lid it was not yet available from Wingstuff, however I felt a need to write a review since there were none. Since this a pretty pricy item to add to your already expensive Wing, and it is something that really Honda should have done in the first place, you would need to want the additional trunk space pretty bad to buy it, which was my case. Beings that I am quite mechanical and with the help from a Cruiseman's video, I did not find the install to be too difficult. I was prepared to take whatever time I needed to get it done right, and I spent about four hours altogether. The fit is good and the finish is close to Honda's, but not quiet the same, the color match was spot on. Since I was doing the trunk light at the same time it was quite simple to add, and a nice addition to my 2019 DTC. I also mounted the Honda luggage rack. It was much easier and less time consuming to do it all at once, but it was a little bit disconcerting to drill four holes in my new trunk lid, but Corbin had them all marked out and it went without any issues. The thing to note about this bigger Trunk Lid, is that it is not constructed in the same way as the stock Honda one. It does not have an inner removeable shell, so you are very limited to what you can mount to it from an aftermarket standpoint. I am going to add the Pathfinder Sequential Spoiler Light to mine, but I will have to adapt the wiring to work with this trunk lid. I did talk to Corbin about fitment of after market parts to their Trunk Lid, but their representative said they did not have the resources to check each aftermarket part, in all I did not find them to be helpful. |
| Got these for my 2019 Goldwing Tour.You will receive a piece of paper from Honda in the box that says go to their website and the accessory section and you can download the instructions. No joy, these pegs are not even in the accessory section. I consider myself fairly intelligent, but when I opened the box I really had no clue where to begin. Called Wingstuff, very helpful as usual, but a Honda piece so they had nothing. Ended up searchIng the internet for anyone who sold these and they were very difficult to find. Finally found them in Illinois, so made a phone call and the Parts Manager scanned and emailed them to me.Once I got the instructions, it was much easier to assemble. Never would have figured it out without them! For the price, the main foot peg part could have easily been built up at Honda and then shipped. The pegs should come already assembled, then you just install on the bike. Even highway pegs come with the major portion of the peg itself assembled. Whatever, another reason I don't buy from Honda.Ok, so now the actual pegs. Installation on the bike was a breeze and no adjustments required. They lined up perfectly from the original ones and they make a huge difference. Went out and put 207 miles on it and they are so nice. No more having to straddle the skinny little factory peg. The entire back half of my foot was on the peg, and felt very solid. What a difference to me for sure. Honda, get with the Touring Motorcycle program. Should definitely have something better than that little skinny peg it comes with, should have floor boards out of the factory.3 stars for no instructions and should come already assembled, especially for the price. |
