Contact Us
| Installed this today on my 2012 and it is a lot easier than changing the air filter. Comes with a protective film on the two parts and once you get that off your halfway there. It went where it is designed to go witjout much fussing around. Cons - I don't care for the way it just sits on the lip of the front lower cowling and it leaves a big gap on both sides on the front end of it. Debris probably won't get in there but they are there. I didn't find the edges dangerously sharp, a lot less dangerois than when I worked in sheet metal. I believe it will do what it is designed to do. Too bad we can't post images of what we write. |
| some items can make a bike just look out of place, but these rotor covers look like they belong and adds a finishing touch. easy install. |
| It's OEM so you know it meets specifications. With aftermarket stuff you can't always be sure, even if the jug says "good for all cooling systems". Thanks, Wing Stuff |
| Purchase this cover since my old one was falling apart. It lasted for over 10 years! That is why I purchase a new one. Great product as long as you take care of it. |
| Absolutely love this winsheild . I bought the short winsheild, my old one had blemishes from previous owner . This was just what I needed .Im 6 foot tall and the wind in the low position hits the very top of my head and theres about 4 inches to look over. Great windsheild |
| Vent fits perfect, works better than stock .Fit was perfect . |
| Pulled my back out when using the OEM center stand, now I can get it on the stand with no problem. |
| Returned my first one because the inside sun screen when pushed up retracted all the way up into the shell of the helmet, had to use a pair on needle nose pliers to get it out. sent it back for a new one and the second one does the same thing. Very poor for HJC. |
| This drink holder was easy to install and looks great on my bike. Large enough to hold most cups and bottles. Love it. |
| Light install was straightforward. Recommend looking up process for getting the control panel out without removing all the plastic, will save a ton of time. Instructions on removing engine covers is lacking - broke a clip off on mine I didnt know was there. Also, the printed Instructions refer you to a YouTube video that refers you to the printed Instructions for zip tie placement. Odd. |
| Replaced an older power pad that was installed by PO of the Wing. Fit great under the seat. Fast and easy install, less than 30 minutes |
| First thing I installed. Make sure you put them on the correct side. They only go on one way. Look great, very easy install. Most difficult part was taking the old vents out. |
