Contact Us
| Great for those that have floorboards, no more lifting board to put down stand. Fast and easy to install. |
| I love them,They look grat, feel great. Easy to install, I would'nt have a bike without them. |
| I don't know where or when it was lost, but one of these was the perfect fit. Just like the factory parts. Not cheap plasticized vinyl! |
| This is one of those things that you like or you don't. It does help protect your shoes or boots and it does look good. The problem is keeping it tight. Mine kept coming loose and I eventually lost it. I know, lock-tite. |
| I finaly got mine and it's everythhing I hoped it would be. It really adds to the bike it works great and easy to put on. |
| These are really great horns. I used them so much for Rolling Thunder here in DC 2 years ago that they actually went out. The fix is easy by using WD40 and an Air Compressor. At Wing Ding is where these were professionally installed by Rivco. They really DO get people's attention. Enjoy them, I do... |
| Keeping with my Amber front-I purchased the amber set of the fork lights. The install was quite easy and I'm pleased with the chrome look of the light housings. However, I did not use the oval sticker pieces to put between the lights and the housing because I found I had to trim off too much to get a really good fit. I've hooked these lights up to my switch. Excellant product. |
| I have had one for years and finally bought one for my wife. No modification of the chin straps is necessary and it can be transfered from one helmet to another when the time comes. Very secure feel and it "clicks" when it locks in. Easy to open and doesn't accidently let go. |
| Great fit and finish. ( I opted for the brushed aluminum ) However there is no information about tunning the antenna for your CB. If you don't know about this you should take your bike to someone that does. You could burn out the transmitting circuit of your CB and that could be expensive! |
| Areal attention grabber! Since installing mine I've noticed most drivers give me extra space instead of creeping up on my rear fender. Great for letting tailgaters know your aware of them, too! |
| I have to have driver board ,( bad knees ) great boards , heal toe shift rod loosens up , allen screw in behind the mounting plate is hard to thighten because of two hole button that recieves allen screw can not be held to tighten allen screw . |
| This is a must if you ride in the summer where it is hot. Also, go to a sporting goods store and buy a "Camelback replacement straw" and heat the end to push over the Butler mug straw. This allows you to drink from the mug without removing it from the holder while you ride. A flip-front helmet makes it even easier! |