Contact Us
| I ordered these quite a while ago, finally installed them, and they are great. Installation was easier than I thought. Look good on the bike too. |
| I think the best advice for this product, is don't get discouraged. If your doing this in your garage, it might be a little overwhelming, only because it takes a lot of time underneath your bike. I was lucky enough to have a neighbor with a bike lift, which made it a snap. It made it real easy, because there was two of us, the holes didn'nt line up exactly perfect, but, with two of us, one could tweak it a little, while the other started the bolts. All in all, it was a snap to put on, looks great, and works great. Instructions said to loosen the exhaust, we didn't do that, we just took the saddlebag mounting bolt out, and the rest was a snap. |
| Seem as good as OEM, but wouldn |
| Works good and the connector is good also. I installed one in the top of the trunk to charge phone and NiMH camera batteries, and one in the left pocket. I have since changed to "N" sized connectors like the BMWs use and Gerbing heated clothes for my GPS, and satellite receiver up front, they are smaller and stay connected better. However this one is used all the time in the trunk and no troubles. |
| Called Kuryakyn direct to tell them they had a manufactor defect that the plastic was not bent enough to go around saddle bags(corner piece) They told me that they had a "bad run" and sent me two new corner pieces at no charge. I compaired the two and you can tell the difference. new one went on fine!! |
| does not stop everything, installs good, I felt the bolts were cheap as I bought the Honda one and the hardware was better, non the less I like it. I have raised my ride height some with new springs front and rear, so it is more effective for me. you should take a strait edge of some sort and hold it from the ground up to the back of the fender to see what all of us are talking about as far as protection. |
| I agree with the others, this thing is way too short to do anything and for what it costs... |
| I have the yellow ones on my Yellow bike, and they look great, I have not had any troubles with breakage throughout the years of use of Bakerbuilt products, and customer support is great if you do need any replacement parts. The one thing with these, they do not work for me to deflect wind inward unless you are going below 40mph, so I remove mine in the warm months. I guess I could tighten them more, but at that point they may break. |
| Good deal for the price, I personally did not notice any trouble with the wiring, but soldering with heat shrink is always better. Not as much side visibility as I would have thought, but then again I like to have my mirrors directed outward quite a bit. I have also been caught in the rain a few times, out in the cold, and so far no troubles at all. |
| Gives a fresh clear view through the windshield and face chields on helmets. I use it everytime I clean. |
| I PUT THESE ON IN ABOUT 15 MIN. THEY REPLACED THE FACTORY TIPS, AND LOOK MUCH BETTER. ALSO THEY KEEP THE EXHAUST OFF OF MY TRAILER AND ICE CHEST. SUPER BUY COMPAIRED TO OTHER STORES, AND THE NORMAL FAST SERVICE FROM WINGSTUFF. IF YOU HAVE ANY PROBLEMS GO TO WWW.GOLDWINGFACTS.COM AND YOU CAN SEE A STEP BY STEP VIDEO TO HELP WITH THE INSTALL... |
| I JUST REPLACED MY KURYAKYN BACK REST WITH THIS ONE, AND I AM MUCH HAPPIER WITH THE SWITCH. IT'S EASY TO INSTALL, AND IF YOU'RE NOT SURE ABOUT THE INSTRUCTIONS GO TO WWW.GOLDWINGFACTS.COM AND THERE IS A VIDEO WITH STEP BY STEP TO HELP YOU WITH THE INSTALL. GOOD PRODUCT, GREAT BUY, THANKS TO WINGSTUFF FOR SUPER FAST SERVICE.. |