Contact Us
| I really like this little piece of bling. It adds a nice touch to the back of the bike. Very simple to install. Highly recommended. |
| Easy install, deflects wind from hands very efficiently. When turned out, the amount of air deflected towards you is amazing. Great for cold and hot weather. |
| installed very easy rode for about 40 miles with not speed control problems but i did grease it very well |
| Great product. Keeps all that little stuff organized. I cut a hole in mine to access the power outlet in the trunk lid and can now leave my phone/ipod etc in the pouch while charging. I also put a screw in the middle to attach it to the lid to prevent it from sagging down in the middle. |
| these are Junk I have a Kuryakyn rack witch is on my 2006 Wing. The Gold wing has never been left out side or in the rain except when we have been ridding. I like most Wing Owner treat ther Gold wing like the baby. Rack has a lot of pitting and the Large in lay fell off last fall while we were out ridding. I am going to replace this item only because of the spacing of the hole and it would require me replacing the Trunk lid to be able to use another company rack. I would not recommend this rack to anyone that can get another vendors rack. They are junk. |
|
I just installed one of these on an AirBag model. Yes, I know it can't be done. It is best to lower the right muffler a tad. Although the fabrication is not so good, these units offer a long life with some loctite and proper torqueing. I have used one for many miles with no trouble pulling a 400 lb trailer. Be prepared for a battle to get it all to line up. I had to stretch some holes, beat, pry, and leave the washers off the lower H bolts to get the fender to pull in. |
| Again, thanks to the reviewers here at Wingstuff and friends that gave me input on what to buy. The rack is definitely good looking and feels solid, not flimsy. On the recommendation of the staff at Wingstuff I ordered the risers for the rack. Because I had read that the risers actually set off the alignment of the posts from the rack, I used some painter's tape and temporarily stuck them on with the rack's posts. Then (like the Kuryakyn video demonstrates) I put painter's tape on the trunk lid, carefully lined up the rack and marked the drill points. Perfect alignment, one 3/8" drill for each post and the rack went on flawlessly. Well, except for the 2 longer screws provided with the risers were too long and the rack wasn't tight to the lid so I used 2 of the shorter screws from the original set of screws for the rack, not from the risers. Other than that, no problems. Installation would have gone very quickly but it took me about 1.5 hours because I wanted to make sure the rack was aligned properly. Checked and re-checked I don't know how many times to make sure. No do-overs here. |
| Easy to install, really makes my metallic black goldwing pop. |
| will not buy cobra;s again..after numerous front tire balances i was told it was out of round, replaced it with a dunlop elite 3...world of difference..back cobra sounds like a knobby it's cupped so bad, have a dunlop waiting in my garage.... |
| Nice bag to keep your trunk clutter free. I only keep one helmet in the trunk, so it works great for me. It's held in with velcro, so it easily comes out if I ever need to store two helmets. Just toss the bag in one of the side compartments. |
| This is a great trunk accessory. Very clean install, looks like it came from the factory. The 1 1/8 hole is a tad big, but I used hot glue to secure it in place as another reviewer mentioned. Thanks for the tip. This upgrade is easy, inexpensive, looks great and very useful. No reason not to do it! |