Contact Us
|
I ordered this windshield from Wingstuff, had it drop shipped to the artists residence who etched the twin eagles on it for me - one on each side of the air vent. I added a picture of it to my photo gallery. Came out very nice! Thanks wingstuff / Rodney for assisting me with this windshield project. You guys are the best! I haven't really had the shield on long enough to make a comment about its benefit, but reading the reviews is what sold me on this one. I clean my shield at every stop when on the road, I don't like looking through bug juice! Looks great on the bike and have gotten lots of compliments already. |
| Put these on my 08 wing a year ago and they are way more comfy than the OEM's. Still look good as Rubber and chrome is like new yet!!! |
| This is easy to install and is great for storing all types of things. |
| I've done both sides and the fitment was good and after 1 year they still look great! |
| Can anybody tell me what model number of actual cigarret lighter plug that works with this 12v plug [email protected] |
| I have this on my bike, but I don't know where the wire ends up? Is it under the seat?, in a compartment? Behind a compartment? Mine is installed on my left handle. Thanks in advance for any assistance. |
| My cowl held up well. I think its time for a new shiny one as this one has been beat up pretty good. Thousands of tiny rock marks but still looks ok. No chrome chipping or peeling on mine. For a big ole piece of plastic, I would say it has done its job! |
| This switch is an easy replacement for the OEM switch. After removing the trim strip, remove one bolt (under the trim), squeeze the panel on the left, and lift it out. Two screws hold the switch in the panel. Also the switch is very easy to locate at night, since the switch has a built in light that is aways on. |
|
This light is a must have. It looks just like the OEM reflector, but it lights up. The light is bright and it matches the light design with the other lights on a Goldwing. It doesn’t look like you have stuck a light on the bike like a lot of other add-on lights do. It looks like it came this way from the factory this way. You do have to drill a couple of holes for the wires, but that’s no big deal. Everyone that sees my Goldwing says they have to get one of these lights. You can’t go wrong purchase. |
| I must admit that I bought this piece because I liked the way it looks, but after riding with it, I definitely notice the improvement. Steering is much more solid, especially at low speeds. |
| This is the piece that folks will see out of the corner of their eye. Because of it's position, it's not an in your face piece, but it definitely grabs the attention when noticed. |
| These mounts are a must if you want to complete the look of chroming your bike. They are small, but provide the finishing touch that you need with chrome pegs/boards. |