Contact Us
| The pan arrived on time and was packaged very well. It took about 15 minutes to install. Just remove the 4 header bolts, pull the plastic shield out a bit, slip one side onto the studs, and then the other side, then tighten all 4 bolts. The front part was easy too, just line up the holes, insert the bolt and twist onto the bracket. The pan fits just fine. It does not hang down enough to interfere with cornering or the center stand. I bought this pan to replace an aluminum pan that was destroyed by a rock while touring in Idaho. The aluminum pan protected the cylinder block so that it only sustained a hairline crank that was patched with JB Weld Steel Stick. Cylinder block had to be replaced when I got home. Hope the stainless pan offers a little more protection. It is thicker than the aluminum pan. |
| What is the ball size and which RAM mount can be installed in this. |
| I bought the Bridgestone front tire for my 2012 Wing from Wingstuff. There were other retailers that had a better price, but I didn’t trust they would have a recent born on date. I received my tire in a few short days and it had a 3 month date which made me happy. I usually get 15k-18k miles on the OEM tires without using any beads or balancer products. I religiously check my psi and run about 3-5lbs over what Honda suggests. I get great even wear. I mainly ride FLORIDA flat/straight roads with annual trips to the mountains. |
| Nice looking easy to fit but didn't work with my kickstand switch. Had to replace the switch DAMN |
| Good fit but cheap plastic I guess I need to read the description better. Had to use more dbl sided tape in order to make the ends stick Really not worth the money....but you get what you pay for. |
| Quick and easy maintenance job. Plugs were already gapped correctly. |
| Does clean up the look of the engine and installs easily but the fit is not the best. They don’t lay flat. |
| It works fine. Fits fine. Just a necessary part if you’re doing trunk lid lights. Although it doesn’t cost much Honda should just have this already on the bike. |
| Lights up the trunk area very well. Make sure you get the required harness to go with it. And warning: It’s a pain to install. I would buy again and recommend |
| Easy to install. Nice to have extra charging spot for your gear. Minimal tools required. Plugs right in |
