Contact Us
| Easy to install. Had these on my last wing. Won't go without them on long summer trips.Only negative is the price. |
| As others have said, it's tough to get the stock bolts off. I used a 2' iron pipe as a socket wrench extension. Even so, my cheap sockets kept stripping. Bought a Husky brand socket and that worked. But the new stand had a manufacturing defect: the right side ear/flange with the mounting hole was welded 1/8" too low. Didn't notice it till I tried to install it. With 1/8" less clearance, after screwing in the right side bolt, the stand wouldn't pivot up far enough to install the left side hex bolt. I had to file off the area directly below the flange till there was enough room to swivel up into place. Then, once installed, when I tried to put the bike on the center stand, it didn't have enough space to fully engage (so the flat part of the stand rests on the flat pad on the bike, as the OEM stand does.) This left the bike precariously balanced. By comparing it to the OEM stand, which is beveled down about an inch near both flanges, I filed the new stand to match and then it worked, swivels up into place where it should. However, since the right side is 1/8" shorter than the left, the bike leans slightly to the right. Doesn't seem to affect getting onto or off of the stand though. All that said, now that it's finally on, I love it. Make sure you leave the bike in Reverse when it's on the stand (as the manufacturer suggests.) |
| Very easy to install. Very comfortable and easy to raise up and down. Should have ordered cup holder at same time however. I've only had these 2 months, but I guess time will tell about the chrome flaking off that I have read in other reviews. Good quality so I'm not worried. |
| After 7 month wait I finally got this kit. Everything was properly packaged and no damage was observed.Installation was very simple and everything fit perfectly. The included brake lever height was just right. Anyone looking to install a floor board kit should seriously consider the Omni Driver Floorboard Kit for 2018+ Gold Wing DCT Chrome |
| Fit great and works great |
| Got it installed but had a bit of a fight trying to line everything up. After towing a Leisure Lite trailer for about 3,000 kms I noticed that the hitch was bending downward where the hitch is joined. I had about 65lbs of weight on the tongue on my second run and some rougher roads for a few hundred kilometres but it did hold up. In the trailer hitch add on this site or the paperwork/instructions that came with it there's no mention of maximum tongue weight anywhere. I took everything apart and did some modifications to beef everything up but this hitch doesn't give me a warm fuzzy feeling when I'm towing. |
| Picked this item up to add a harness for a trailer. It made the install much easier than without. As usual , Wingstuff delivery was fast. Am happy all the way around. : ) |
| The chrome has some mile abrasions in it so we will see how it holds up. The installation was pretty easy. Put some tape on the trunk lid, lined it all up and marked the legs. I took my time and did one hole, checked, did another, check and so on. Total install time was about an hour. It looks good on my yellow 2010 even with the spoiler. |
| These pegs are really versatile and sturdy. It takes a while for a non-mechanic to put them on, but the directions are good and easy to follow. |
| Fits perfekt and looks good |
| Keep the bike clean and look perfect.Easy to install. |
| There is a gap at the back of the bike, With this red taillight it closes that gap and bike has a perfect view from the back. |
