Contact Us
| Added these to my 2020 GW last year and are a great addition for wind and heat control on the lower body. There are 3 adjustable positions that allow you to totally block wind, while 2 positions allow some heat and wind in. The heat is nice to have on the lower body when outside temps are cold. |
| Ive read some reviews where the pad doesn't fit the kickstand well. All I can say is that it fit my 2010 Goldwing Great. it's on and not coming off unless I take it off. |
| I installed tis 5 to 4 wire convertor with the 7673 wire harness. first install the multi-plug adapter that comes with the 7673, then the convertor, then the 7673 harness. Works great. No issues for me. |
| The 7673 was installed with the 7675 - 5 to 4 wire convertor. all worked perfectly the first time. the only hindrance were some of the plug identifier labels, they interfered with the mating of two plugs. I had to remove them, then it was a piece of cake. the included documentation had good pictures of the different connectors so even without those labels. I could identify each of the different plugs. Ive seen some bad reviews on this but no issues here. My only advice..... review what needs to be done, understand what the directions are telling you before you do it. There was one thing the directions did not spell out, and that is I needed to plug in the 5 to 4 convertor before the relay wire harness. But that was easy to realize, I took my time, planned my route and soldered all but one of my connections. I purchased a 4 wire holder to secure the flat 4 wire connector in place and used a 4 wire extension to the trailer that I just plug in when I use the trailer. It can be found on etrailer.com |
| Plug and play and does what it says. I had changed all my button led's to red so it was a nice surprise to see that this also lights up red. |
| It's plug and play, and works. Not much else you can ask for... |
| Installation was a breeze for me. Installation took me about 1.5hrs. Life is so simple when I can open and close my garage door by just pressing a button on my bike’s console! Money well spent.!!! |
| I have purchased the Tail Light Trim. However, the installation instructions are very poor and difficult for someone who is not used to install electrical equipment. The instruction contains only 3 points: 1. Remove Saddlebag Rear Center Cover (1) by releasing its tabs. 2. Install Central Taillight Trim Light by snapping into place. 3. Connect Black wire to ground, White wire to running light and Red wire to brake light So far so good. Point 1 "no problem" Point 2 "no problem However, point 3 is not so feasible. There are no cables visible at this point. The length of the wiring harness indicates that I can somehow connect the light only behind the top case somewhere below the saddle. Therefore at least the saddle must taken off, but also the way underneith the top case is hard to get through. Therefore I gave up for the moment. Thought installation takes approx 20 minutes, but for sure it will take much longer. Even the light looks good, the way to install it did not fulfill my expectations. Support, even directly from Add-On is not suffcient. |
| ...for removing/installing body panel pins 📌 on 2018+ Goldwings |
| This is the way to go when doing a Brake fluid and Clutch flush. |
| You never go wrong with Honda OEM oil filters. Every Oil change I use these. |
