Contact Us
| If you are looking to dress your goldwing up theses really make a big difference cosmeticly and the added lights really increase the saftey factor |
| well made,look great,and most of all alot more comfortable than pegs |
| Useful Never stop only go! |
| It's solid. It's easy to install. It does it's job better than anything I've found...AND IT'S CHROME. Sure, may cost a few bucks more, but did I mention IT'S CHROME and not plastic, and you pop it in the trunk when you don't need it, and the mount works with OTHER accessories TOO. Can't beat it! |
| I was disappointed when I received this unit because installation requires cutting into the Goldwings wiring harness. In today's market I expect a little more effort on the part of the manufacturer to integrate aftermarket parts less invasively and more seamlessly. Add a bike specific wiring harness and charge a little more! |
| I was dissapointed when I received this unit because installation requires cutting into the bikes wiring. I'm not willing to do this so I'm sending the unit back. |
| For the price it's a great hitch but I don't like the way it's fitted. The forward mounting points need to be sandwiched between the frame and the saddlebag frame. This forces the saddlebags out at the bottom and it's quite noticeable when you go to reinstall the rear mudguard. No problems with holes lining up but it does seem to be a very tight fit. Maybe that's good, but it makes it a little awkward. Thought instructions were OK and it took me about an hour on my own. |
| Easy installation and it looks absolutely OEM. Can't fault it. |
| Very easy installation and works just fine for a 5 wire trailer. Good quality and well weather proofed. |
| HAH - that's funny, it took me all of a minute to notice the tightness if mounted as pictured so I TOO installed the unit point-up. 1. I am not happy with the finish of the gold. It's not smooth. It's obvious to anyone who really looks at it that it's an inexpensive plastic add-on. I purchased this to help make sure I did not damage the paint when using the key on the trunk, which I rarely do since I use the remote to lock and unlock. I am satisfied overall with the unit, but I do wish it had a better finish. |
| Just put these on and haven't ridden with them much other than an initial test ride. However, I could tell immediately that there was far less turbulent side air on me than there was with just the Baker Hand Wings on the mirrors. I also think they're the least offensive looking deflectors and actually have decent looking lines. I'm not into big ol' honkin' deflectors no matter how good they work, so I don't plan on any lowers especially since as they are, these will also let me use my Mick O' Pegs without getting in the way of my legs. My only missive is that they don't quite fit up and form around the mirrors and fairing as closely as I'd like for a more finished look, nor does the vent wing have much adjustibility or effect. These are basically for long rides with the wife. They're easy to install and remove, a plus. |
| Looks like I am the too critical guy. 1. The angle of the actual armrests themselves doesn't match ANY of the lines on the bike. They position your hands much lower than you elbows so it is uncomfortable and clashes visually. 2. The pads are VERY slippery. This has become a significant annoyance for my passenger who is constantly repositioning her arms because they keep sliding. (This would not be such an issue if the armrests were level with the ground.(This would also line up with the rest of the lines on the bike.)) 3. The cup holder is a very freaky size. I am not at ALL happy with the size of the cup holder in any way shape, or form. Would be so much better if just a bit larger or smaller. 4. ALL of my parts are install by First City Honda dealership. FYI - a standard to-go cup from your local restaurant will usually leak ALL over that side of your bike. I found this out the hard way doing less than 55 mph. Use containers that have some kind of seal or sealing lid / cap. |