Contact Us
|
I love the look, but I do have some comments. These re-use the OEM screws from the original moldings, and I think they might be a little too big. You can hear the mouldings crack as the screws go in. Mind you, it was only about 10 degrees C when I installed them. Sofening with a hair dryer, or drilling them out a bit might prevent. Make sure you understand how the trunk moulding fits together before attaching to the bike. The wiring sticks out the end of the center section in the way it is packaged, but cannot remain there once installed. If you only discover this once it is on the bike, you will have to remove it again. For the saddle bags, Kuryakan could have given a couple inches more wire for the side pieces (I had to extend mine in order to install them), and the rear piece has you drill two holes on each side to pass the wiring. These holes just cry out to be a bothersome leak in the saddlebag in the future, so I went and spent the $2.00 to buy rubber grommets for those holes, something else that should be part of the kit. But all-in all, a great enhancement to the bike once installed. |
| I particularly like the electrical section. Currently researching the circuit for the signal light cancel switch to activate a garage door opener. |
| A little difficult to install, I ended up using a wood clamp - gently - to snap the two halves together. My bike already had a set when I purchased it, but they were either an older design, or were installed incorrectly, and the rubber insets kept working themselves out at the ends. The replacement set has a single piece rubber insert, where the ones I removed had two piece equivalents. Did the installer of the originals cut them in half to make installation easier? If that is the case, they ruined them. |
| Fits perfectly. It can be flipped over, so if you want perfect symmetry left to right, it will also install on the left side. I am not tempted, but I like it on the throttle. |
| So far so good. Easy to install and a good fit. Definately the look I was going for, but like most accessories Honda, they sure don't give them away. |
| Another empty space filled with Bling...excellent. |
| Really easy to install, but they appear to be just slightly too wide for the fender. I added an extra layer of tape to the sides where they curl around the fender, just to be sure they stay. |
| Really easy to install and add a finishing touch to those unfinished holes. |
| This is a MUST buy for all Goldwings for safety. Definitely enhances rear visibility with the LED's and I've even purchased an adaptor so this spoiler is used as a running light and a tail light. I installed it myself, but you have to get over the fact that you are drilling holes into your 20k motorcycle and go for it. Instructions were ok, but I learned more by reviewing other people’s experiences on various online forums. |
| Very easy to install and quick to adjust the settings if you have a passenger that needs more room. Great back support and makes my riding day a whole lot more comfy. I bought mine from a friend and without written instructions only verbal instructions and it went on easy. |
| Nice addition to the side panels. really brightens things up - and is an easy to install. Instructions are easy to understand and comes with a silicone to glue it to the bike. |
| Too easy of an install. Be careful - adhesive on back is very sticky and you only get one shot at getting it right. |