Contact Us
| This is a great product, makes riding without having to constantly hold on to your beverage more enjoyable. Not only are the arms moveable, but when you do not have a container you can fold and store the holder under the arm. |
| Great product. I was pretty nervous about drilling holes in a new motorcycle. I double checked my measurements and even ran a level across the armrests while the bike was on it's center stand to ensure they were staight. They look great and my lady loves them. Keep in mind that you have to swing them outward in order to open your trunk. |
| These are great, went with the lighted model. Put 4000 miles on the bike in the first two weeks if I had thess on the bike it might have been six. Sure make the long ride much easier on the rider. |
| East install, looks great and covers to ugly sun faded gray. Now if someone would come up with a cover for under the the knobs, I'd be in pig heaven. |
| If you don't have these lights, get them. Easy to install and a great safty feature. |
| sorry,meant to say left board will NOT stay in stowed position,,,,see!! had another drink |
| Ok,they are very pretty and wife likes them. BUT I can not believe the trouble I went to install little bearing and spring,,,very cheap Kuryakyn,,unbelievable,alos my left board will stay in upward position. Maybe I installed stupid spring in,,,guess I will try to reinstall after a lot of drinks |
| As one of the reviewers already mentioned, the trim piece has a little less curvature than the fairing, otherwise I would have given this item a 5-star rating. Installation was straight forward and quite easy. Just be sure to apply more than average pressure to the outside ends, while holding it in place for a minute or two. Otherwise you will have a gap at either end or both ends. Nice accent piece, particularly if you have the Knight Rider leds installed. |
| Nice to have around. But they do not work on the fairing pockets. |
| Easy install and good looking. |
| I recently purchased this and wired it directly to my battery. This is smaller than my old compressor and will give me more space. I haven’t had to use it yet and I hope I’ll never have to. |
| I installed the +4 without any problems. This does not come with a shaded area at the bottom of the shield like the stock unit so be sure to remove all the old plastic and glue from the horizontal area where the shield slides up and down. Use the velcro type strip that comes with it and it'll work just fine. This area will show and will need to be done neatly and correctly. This windshield is a great improvement and is worth the money. |