Contact Us
|
Very nice looking and functional item. Install was easy enough, directions adequate. My bike has no CB antenna, so left side trunk drilling was a little interesting, as the holes are very close to the inside front wall of trunk. I used a hex/drive drill bit on a 1/4" ratchet. The plastic is soft enough to drill that way, just take it slow and easy. Also, don't worry about the fact that they are mounted to the side of the trunk and not to the bike's framework. They are plenty solid after all hardware is tightened up. All in all, a very good product. My buddies flipped out over the integrated cupholder! |
| Very nice addition to the plain part of the trunk. The fact that it is also functional is a bonus. The install was easy, directions and drilling template were spot-on. |
|
Update, Finally have gotten to ride in some OK weather. The rest is all I'd hoped it would be. Very comfortable. I can't imagine anyone not wanting one! |
| I installed on my 07 fully loaded wing, No problems... Great Hitch |
| I bought a pair of Avon's front and back. I put 16,000 miles on them both. I ran the front tires with dyna beads and the rear with regular stickons. I am very pleased with the ride and mileage. I have put on another pair last week. Do not buy them from dealer, they charged me $281.10 for the rear alone, and that is not even putting it on. Wow they should of kissed me first. |
| This is a well designed belly pan. Very easy to install and I feel very confident that the belly of the bike is now protected. |
| These look good and are easy to install. The only thing that I did not like about these was that they do not set flush against the bike like the originals. The frame bolt clearances on the backside of these are not as deep as on the originals. The lack of depth causes them to not set completely flush. |
| Look's Great..Better than the scare cover |
| This shield snaps down tight and seems to be well built only time will tell |
| These seem well built and a small enough bundle.I hope I never have to test them!!! |
|
ok put it on an 07 my buddy a mc mechanic did most of the work it went well except a little sqeezing and pinching to get the bolts on the side to line up . only problem that we found was when putting it back together the rear cover would not fit in smoothly even wioth the snapping in at the bottom so beware when you install the hitch the H bolts don't put a washer and lock washer on the bottom h bolts the bolts comes out just a bit to much and the rear cover doesn't go in at the bottom easlly b.t.w the wiring harness for the harly/1800 is a snap to install plug n play good luck guys graham |
| Everything went well untill it came time to put the center rear section back on bike. Panel hits head of bottom bolt on on side! Will either have to get low profile bolt or try to shift brackets to one sid ebut could run into the other side hitting! Instructions from website where very helpful vrs what came with product. Took about four hours by myself taking my time. |