Contact Us
| Super easy install less than 2 hrs to install, the downloaded instructions were very helpful especially the pictures, the only comments I would add are, on my 2001 Goldwing I didn't loosen the mufflers as called out in the instructions, the forward hitch arms (with some slight outward prying of the side bag mounts)slid into there location, also I replaced the 2 original bolts that are to be reused for the forward hitch arm & side bag mount, with M8-1.25 X 30 flange bolts, this allows for almost 3/4" of threads into the frame, I also replaced the 2 lower bolts on the "H" bracket with low head profile stainless steel cap screws, the bolts from the kit chafed on the rear plastic center fender. A very solid install. |
| Real easy installation; but took a little longer cause I have a trike kit on my gl 1800. But it was nothing a dramil couldnt handle. Made a duplicate on cardboard; cut it out; trased it on the front part of belly pan and it was all over. So it will go on a trike and if I might say; it looked like it came that way, Ride on. |
| Install was a piece of cake.. Took about 45 mins and had to do it twice because I forget to install the speed nuts on two locations... Holes all lined up and it looks great.. |
| Same USA mfr as the states flags- appears to be of good construction & durability |
| Initial impression of flag is one of quality & durability. It does state in the mounting instructions that its intended for use at 'moderate' speeds, whatever that general term means ;-) Time & miles will tell, but appears to be of durable fabric & construction. |
| A little more bling for the front of the trike. Quick and easy to install. The only bad thing is now I want to add more accents to go along with them. |
| I really like this cover. Just went out and put it on my MotorTrike and the fit was great. I had no trouble putting the cover on by myself, but found it easier to leave it zipped up and stretch in over the front then down over the back. I have the aquashields on my trike and it is quite low so I probably won't hook the straps underneath, but it they would reach if needed to. I have never had a zipper before but like the idea of being able to access the trunk without removing the cover off half of the trike. |
| Just put them on my trike. Easy to install and look great with the lower vents. I am ready to buy more chrome accents. Love that bling! |
| These are great! Only took minutes to install. I only had to remove one since the left stock vent is on a highway somewhere where it flew off my trike. The chrome look is much better. |
|
Here is a product that has a great price, fantastic look and is easy to install. I like to give credit where is earned and the video's are usually very helpfull but in the this case it is terrible. If you have not installed the adapter with another addition you will need to purchase it. If you want to make that middle section on your bike shine this is the part you need. |
|
Just finished installing on my 2007 GoldWing. Nothing really difficult about the install, and the updated installation instructions were a big help. Took a total of 3 1/2 hours, a lot of which was simply getting bolt holes to line up. The hitch feels really solid and secure. Now I can mount my Golf Bag rack to the hitch! |
|
Installed this.. very straightforward but follow instructions. I do suggest using an alcohol swap to clean the seat where you stick the gasket on so it gets a good stick down. I also trimmed mine a little top and bottom so it didn't hit the seams and not sit right. Then take the alcohol swab and then wring it out so you can take a drink before you cut the seat. (the scary bit) It takes time to knife out the foam so go slow. It is so comfortable I cant beleive it. I will also be sealing around the cut to avoid water issues.. Also I am concerened about the square corner where it folds forward this could slowly dameg the seat over time. Will tape this to avoid.. damaging the seat. Really pleased with it.. Ray NZ |