Contact Us
| These work. Bottom line just look at contact patch area between roller bearing & ball bearings. On my 06 the bottom race had a piece of metal under it, so original bearing was never "square" to steering head. |
|
This works well, I modified the (drivers side) notch to fit better & then trimed the brake line bracket to make it fit lower on lower fork legs. How well this works I'm not to sure because I installed the upper & lower triple clamps & roller bearings from these folks. ( lower race on my bike had a metal shaving under it) Low speed handling, is much improved. (I live on dirt & gravel road) |
|
I installed this & modified it slightly. The Inside curve did not match the brace curve therefore was filed until it did. (mounting is between brace halfs) Works fine. |
| I just installed these Pegs. My wife is 5'10" and had problems stretching while traveling and would get cramps in her legs. We went on a short 200 mile jot today and she loves them. If your wife is unhappy then your life isn't good. I made alot of points installing these. Worth every dollar. Looks nice on bike and not in the way when stopping to put your foot down. Only problem was the through bolt on each peg needed to have a tap run through it because of slag when chroming. Can't go wrong keeping wife happy. |
| Easy install. The plug was just under the left faring pocket. There was a circle with a dot in the middle on the outside of the pocket letting me know where to drill. Used a 7/8" spade bit and then used a file to size perfectly. Now I have power for my iPod / iPhone though it does run a bit hot in there. |
| Nice quality. Very useful. Helps to organize and hold in place the small things you might keep in your bags. Each uses 3 screws and 2 of them didn't work for me, so I had to find 2 of my own to substitute. Not the end of the world and I'm very happy with the finished product. |
| Looks great. Simple peel and stick install. Can't go wrong here. Just make sure you have it where you want it before you push. |
| Nice quality and fit my 2010 Wing perfectly. Helps protect the saddlebags/trunk from things which might end up bouncing around in there. |
| Another peel and stick piece. Simple install - just take your time to get it where you want it before you press it on. Adds a nice touch. |
| Looks great. Easy install. Not a perfect fit, but good enough. |
| Nice addition to the rear of the Wing. Easy to install. I share the concern about there not being enough adhesive tape used, but I guess time will tell. For now, I'm very happy. |
| Wow this stuff is amazing. I will use it alaways cleans up the shield better than new.Smells good to. lol. |