Contact Us
| I had to replace a tire due to road damage, this tire had the Dyna beads in it and they did keep the tire in balance as stated. The only thing that I did see when the tire had been removed was that the wheel or rim which ever you prefer to call it had some etching marks plus a little showing on the valve stem. This caused me to think of what might happen with continue use over a long period of time. I’m trying a different type of beads in the new tire but I’m still running the Dyna beads in the other tire so I can get some comparison between the two. As of now both tire are in balance and the only different is the beads in the older tire fall to the bottom after stopping for any length of time. |
| It starts the wing really fast for that it is a 5 but installing it is a 3 they can and need to make it the same as the original one fits all is a bad idea |
| One of the glue tubes I received was dried out so I had to use some of my own but otherwise install was a breeze. |
| I think the rubber nipples make it a bit tighter then it needs to be. They are also a bit stiffer then I would like. I installed this in the forward bolt instead of the rear to be used as a drivers cup holder and it really works well. |
| I had no truoble following the directions and putting this on. Been using it for a couple weeks and it is great. Very happy I got it. |
| I installed a set of these a week ago and went on a ride a couple days later that started out at 26 degrees and a high of 40 degrees. These made a huge difference in keeping the wind off of my hands especially and letting my electric gloves work better. Took an hour to install but probably could have done them in 1/2 hr if I had really tried. |
| Ok, so there's one thing that I'm not entirely sure about with these and that's the fact that they replace the screw that goes into the bottom of the mirror itself, but given the configuration, thats really the best way to bolt them on short of drilling holes. The instructions say to add loctite though which I did, so it shouldn't be a problem. The difference between having these and not having them when it's 20 degrees F out is night and day. My finger tips no longer get the blast of wind even through my gloves. They are great.I would recommend them to everyone. The position "ratchet" system is the basic plastic gear type on plastic gear type that holds it in place, and it works nicely to hold them in place even up to about 90 mph (that i've tested). over all, A+ |
| These are easy to install and really look good |
| As others have said this needs the 35mm screws to fit it properly. as the 30mm screws are just to short. Once on it looks good |
| This was easy to install good for charging up your iPod and phones |
| Bought 2 of these. One for each side of the bike. They looked good. Bit of a PITA getting the antenna clocked right but after that they did look nice, until today. I rode under a branch, not real low because I didn't have to duck but it pulled the antenna's back a bit. Parked the bike and noticed the flag poles where gone. Both of them snapped off at the pivot. Almost no contact at all as the antennas were not bent at all afterwards. Very unhappy with these. They were less than 2 weeks old. |
| J&M just makes quality product that fits like a glove. It's that simple. |