Contact Us
| Perfect for the GL back seat grab handles. I attached two as illustrated- one one each side- does not interfere with getting on and off the back seat. Will secure a wide variety of hard cups/mugs. |
| Put mine on in about 40 minutes. Just put bike on centerstand and use a short cheater pipe that will fit over the end of ur hex wrench and ur box end wrench for the other side. Once u break them loose then put ur quarters in between the coils on spring, $2.75 to be exact. LOL. Use masking tape to hold the quarters in. Take bike off centerstand and put on kickstand and the rest is easy. Didnt need any tools to take off spring or put back on. Went on by hand. Great tip from the members. Reason this stand only gets 4 stars is that it don't fit perfect in the muffler groove. Its ok, nothin that jumps out at u. But there was no reason for MFG Co. to not make it perfect. It would have been easy to tweek in the design phase. Well see how long this stand holds up. See you out there. |
| I purchased two of these kits. They work on different frequencys so I had to install both sending units on my bike. The problem is neather will work when they are both installed. I had to install a two position switch with a center off inbetween the two sending units. Now when I am riding two up I switch it so only my wifes helmet works and when I am riding solo I switch it so only my helmet lites up with the brake light. I installed both sending units and the switch inside the tail trunk lid. The wiring is already there. The switch on the light has five positions, off, on only with your brake light, on stesdy all the time, slow flash, fast flash. |
| For some reason, this is not as comfortable for me as I expected. |
| Easy to install - very noticeable - look great - worth the money! |
| One more step along the way to chroming everything in sight. Easy install. |
| This was easy to install and provides a subtle dress up of the front fender. |
| Installs easily and looks good with a chrome or stainless steel cup inserted. |
| Having installed the plug and play harness previously made this installation a breeze. Along with the rear rear fender tip run/brake light, this really transforms the look of the bike's rear end and enhances visibility to other drivers. |
| Having installed the plug and play harness previously made this installation a breeze. Along with the rear vertical run/brake lights, this really transforms the look of the bike and enhances visibility to other drivers. |
| This accessory makes installation of lights on the rear of the bike a true plug and play experience. However, installation of the harness itself requires a little patience and perseverance. I had a little trouble locating the correct connector to hook into under the seat. I also had a little adventure routing the harness to the backend. It was a breeze once I figured out the right route; but for some reason it wasn't obvious to me at first. Anyway, when all was said and done, it was worthy it! |
| These absolutely transform the look of the new Goldwing body. They require the plug and play harness, which is not all that easy to install; but it is worth it!!! |