Contact Us
|
I had these grips on another wing and they were great! These look just as good and installation was easy. The instructions were very good . The only problem was the glue both tubes were hard and would not come out of the tube . I purchased some glue and the problem is solved. |
|
The outer edge of this component appears to have been either water jetted or Stamped with a quite aggressive die. If I had been prepared before hand I would have given this some TLC before installation (it doesn't look too bad from a distance) however I also installed a Superbrace at the same time giving more attention to it. Installation was simple, removing the stock screws was a bit agitating given the type of "thread glue" used at the factory. Rain will keep me driving my cage until Saturday after which I should be able to provide my review on its' performance. |
| Have had this on my bike for 2 years and wow doesn't even look worn. Rode bike to sturgis last year and to the tail the year before and what a difference on the old back. Combined with the air hawk seat great ride that's for sure. Just have to get over the cutting of a hole in the seat that hurts the most |
| I love these! They really keep the wind off of you when it's cold and direct the breeze when it's not. Be careful when drilling into that side fairing strip. I didn't have my right side strip supported properly and it cracked. I highly recommend these. |
| I had a real problem finding the 14 pin connector. Routing was ok and it makes rear lights truely plug and play. Well worth the money. |
| Instructions could be better with clear and closer pictures. |
|
I installed the sensors on my 2008 Comfort/Navi wing this morning before going on a chapter lunch ride. The unit works great but it interferes with the Honda built in electronics. Once the sensors become active, I can change volume but it has no effect on the audio level, when transmitting on the cb, the radio does not blank and none of the buttons on the shelter work at all. I removed the sensors and also took the batteries out and the problem is resolved. I was really looking forward to using these! Now I am out almost $200. Jim Burleson, TX |
| The Mini Arms for the Ergo II Highway Footpegs are a great improvement for taller riders! I am 6' 1" tall with a 36 " inseam. Leg extension is the only concern I had with the Goldwing and the Mini Arms corrected that issue for me. They are simple to install and well worth the money. |
| I agree with Kent, Englewood, CO. The backrest is essential on a touring bike. My girlfriend selected the Utopia from my wish list as a birthday present 2 years ago. The backrest looks like it was intended for the 2009 Goldwing. I did the installation myself-- about 2 very careful hours. I have about 50k miles since, and am grateful every mile. 5 stars, for sure. |
| I don't like the stock pegs on the Wing. My old feet like the full length rest. I traded a VTX1800 for the Wing, so was spoiled to floorboards and heel/toe shifter. I put these on my Wing the first day, 70,000 miles ago, and have been very satisfied. WARNING---- DO NOT TIGHTEN the mounting bolt for the shifter. Some play is required in order for the shifter to work. LocTite, as noted below, would be a singularly bad plan. I have not scraped the boards while turning, but I ride conservatively. Boards are not for everyone, but I like them a lot. |
| This was one of the first additions to my 2009 Wing. The stock kickstand d seems flimsy, and is ugly as a mud fence. The Khury chrome stand has a bigger footnote clean lines, and looks so much better on the bike. 30 minute install, at most. It has been in use for 3 years, 70 000 miles with no change to the finish. Some Khury parts rust, but thus one is good, so far. Excellent addition. |
| This is a good quality bag. The zipper could be better with bigger teeth, but I've had no problems after 2 long trips. The little shoe-shaped side pockets look better than they perform, though. They are too small for shoes, and the shape makes then unhandy for just about everything else. Perfect fit for the Khury trunk rack. 5 stars. |