Contact Us
| I added these lights to my 18 DCT Tour and I think they look very nice. The sequential turn indicator function is very cool. They are not necessarily a substitute for fog or running lights as they are not as bright as those lights for forward visibility, but should help make you more visible to oncoming traffic. The fit when installed makes them look as if they are OEM lights. I connected the wiring to my Show Chrome fuse block. |
| Another accessory that everyone should consider. I had my previous GL towed because of a flat and they had some issues, This is an economical, quality solution to the question: "Where do I tie down my bike?" |
| Perfect accessory - every owner of a 2018+ GL should install these. Work perfectly, easy to install. |
| I had originally ordered the cheaper bags but they did not fit. These are a perfect fit and even allow me to store a few tools. If it goes in the bag it fits in the bike. It's convenient to load and unload when traveling. They are well made but I think the $114 price is a little high. I still gave them 5 stars because I can take everything to and from the bike in one trip when I travel. They also make good range bags when I go to the gun range. |
| Bought a set and can't seem to fit as they keep falling off. As seen on other reviews - will have to add 2 sided tape. |
| Had these installed at Wing Ding. Couldn’t be happier. Very nice rearward placement with slightly more angle. Always me to sit up and position myself into the bucket of the stock seat much better. Also allowed better throttle wrist movement due to the new bar placement. |
| I in no way consider myself a motorcycle mechanic, but I also can't pay dealer prices for all the things I would like to do on my 2018 DCT. I purchased these because I needed to move my tour pack back to stock position. At the suggestion of my local dealer I paid him 300.00 to have it moved back 2" and that was a huge mistake with the Corbin seat that I have. It left my wife sitting on the outer edge of the seat which has a ridge on it. She was not sitting in the pocket. When I ask about moving it back his answer was " well it won't be any more to move it back to stock than it was to move it originally. That meant another 300.00. So I decided to buy these videos. Everything went as planned. No problems at all. I took my lap top to the garage and begin a step by step procedure following Fred's videos. in 2 hrs I had my trunk back to stock. I look forward to using these for a lot of my maintenance and accessory installation, |
| Several parts to this review.First and what most want to see. Installed it, it works well. I give it a 5 for fit, install ability and performance however me only tested it at home. No real install instructions for most I believe would knocks off two stars. I have first a gen 2008 wing which does require the seat to be removes and drilling a hole through the bottom of the trunk to pass the cables from the trunk to the two-wire power plug under the seat and to run the larger multi pin connector up to where the CB connector is. Judging from the reviews it would appear the 2nd gen wing the cables are in the CB trunk compartment so make sure one orders the correct CB or the first gen wing or one will wonder why the cables are so short. To describe where 1st gen wing CB plug is located just looking at the bike, the right-side vent louvers just below where one’s knee would be while ridding. Behind and near the louvers is the CB plug. Not to hard to get to. No need to remove the entire shelter. Take the right glove box out, I did remove the door lever cable to get the box out of the way. Remove the edge body trim piece. Remove edge screws, Mark them as they are different lengths. After the seat is removed just in front of where the seat was there is a bolt on the lower edge right side securing the shelter remove it. Can’t remember there may have been one other screw at the bottom. That will allow for enough flex to pull the bottom right side of the shelter below the vent louver to gain access to the CB cable. With not much effort it should flex enough room if not after a slight test pull check for any attachment points or screws that need undone. Looking for the cable mine had a very easy to see label saying “CB”. One will have to reach up and under to get to the cable connector in order not to flex the shelter too much. There is room to tuck the cable under the bottom edge of the shelter back toward the seat. It is really not much of a job took me about an hour taken my time. The radio came two filters that plugs inline to the fuel pump and fan to keep electronic noise down. I did not install them as I did not experience any background noise. If need be after use, I will install them. Once the right side is loose, at that point it is plug and play. I did get an error at fist. Might have come for residual affect of the previous Mp3 CB. I did a up and down change on the CB channel selector and error went away. Antenna kits have good instructions install easily. Second part of the review. My bike (used) did not have a CB radio. I purchased a wingstuff CB radio they sold thousands of 4 years ago. The CB radio called a Mp3 CB radio. The owners of the no longer business name is Pete. The radios work great for a few years then the start having trouble. I know of four who purchased them and ended up trashing them. I was surprised wingstuff sold such a crappy product. If one sees a used wing CB for sale make sure it is NOT a Mp3 CB. |
| Great quality product and reasonable price. Very well made, robust material and good fit in panniers. Product promptly despatched and reach us in the UK without problem. Very please with liners and service, will use you again! |
| First off they look awesome on my gl1800, the packaging was very impressive and they even shipped the drill bit you’ll need for the install. The instructions were spot on and very simple to follow, it took 10 minutes to install, and looks awesome.I will definitely recommend this to all my friends |
| Love how easy it is to use. Bag is huge, you can pack a ton of stuff in this thing. I do not feel it while riding and really allows you to bring whatever you want on a trio |
| I had another brand on my gl1800 and they were flimsy and didn’t work well. I just received my Air Wings and these are fantastic. Great construction super easy to install. I will definitely recommend these to all my friends |
