Alias:
Trevor
About:
- Nothing entered yet -
Occupation:
- Nothing entered yet -
Favorite Quote:
- Nothing entered yet -
Member Since:
12.15.2006
Bike 1:
Billet Silver 2006 Honda GL1800
Bike 2:
- No Bike 2 -
Bike 3:
- No Bike 3 -
Trevor has not yet written any comments.
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
08.17.2010
4 Stars
I have the tubing in the trunk lid seal but decided to add these also. After fitting, if your lid is hard to close, remove the trunk lid lock loops and elongate the holes. This allows you to pull the loops down away from the trunk lid and adjust the pressure required to lock the lid. This way the bumpers are still full height and prevent chaffing without requiring to slam the lid. |
Centramatic Stainless Wheel Balancers for GL1800
ITEM CODE: CTMGW100-102, SKU: CTMGW100-102
11.13.2009
2 Stars
A rotating mass in balance should not vibrate as graphically shown in their own video. A Wing in neutral at 2500 rpm on the main stand does not vibrate. These things are not mounted on the Wing as per their video demo. (the ring is mounted on the outer edge of the rim on a small wheel in the video, (it is inside the disc diameter on a Wing).Why not set up a Wing rear wheel with the single centramatic for the demo. My basic test has shown the rear wheel did not balance. It may be that the front wheel when fitted with two balancers will work. Trev. |
Centramatic Stainless Wheel Balancers for GL1800
ITEM CODE: CTMGW100-102, SKU: CTMGW100-102
11.07.2009
2 Stars
Having received these units, as others have said, very poor finish. Mine look like they were sand blasted and painted to a very rough finish, like sand paper to the touch. I had thought from the video that these things have a Moly oil in the ring? Why do mine sound dry when moving the bike by hand? I have only fitted the rear so far as it cannot be seen. Started the bike on the main stand and let it run in 5th gear up to 80 kph indicated speed. My trunk lid was unlatched and was bouncing up and down. I do run a car tire on the rear but so far am not convinced about these things. I am unlikely to fit the front units due to there ugly appearance and poor finish. Trev. |
Wish List
- No Notes Yet -
VIEW - No Notes Yet -
Original Wish List
- No Notes Yet -
VIEW - No Notes Yet -