Alias:
Ken
About:
Been riding a few years and member of GWRRA in Shawnee Oklahoma.
Read More
Less
Occupation:
Aviation
Favorite Quote:
It takes less time to do something right, than it does to explain why did it wrong.
Member Since:
08.15.2009
Bike 1:
Red 2008 Honda GL1800 Prem Audio
Bike 2:
- No Bike 2 -
Bike 3:
- No Bike 3 -
Ken has not yet written any comments.
Chrome Lower Front Cowl for GL1800
ITEM CODE: BB52608, SKU: BB52608
09.13.2010
5 Stars
These are a pain to align & install - on any bike. But, well worth the trouble once complete. Get the timing cover while you're at it! |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
09.13.2010
5 Stars
Instructions are good. I like the firmness when truck is closed. |
ITEM: KU7316
08.31.2010
5 Stars
Use with the KU7300 adapters which look quite different than the photograph. You pull the rubber grommet back around your mirrors and then you can pull the wires out. The "Y" connectors will have two accessory outputs. You can run stealth lights up the shelter by only removing the trim strips, pockets, and speaker covers. |
Adapter for LED Mirror, Front Reflector, Stealth Lights
ITEM CODE: KU7300, SKU: KU7300
08.31.2010
5 Stars
These look quite different than the photograph. You pull the rubber grommet back around your mirrors and then you can pull the wires out. These are actually "Y" connectors with two accessory outputs. You can run stealth lights up the shelter by only removing the trim strips, pockets, and speaker covers. |
Kuryakyn Chrome Luggage Rack w/Rubber Inlay for GL1800
ITEM CODE: KU7151, SKU: KU7151
08.22.2009
5 Stars
If you order the riser kit too,you can remove the inner trunk liner and mount all four holes inside (all within the outer shell). That's what I did. But only two bolts will work from each kit, the other two are too long (made for going through the inner liner). Get a helper; set up the whole thing with risers on top of masking tape. Trace the big risers, "x" a center whole, then drill through that. You may want to get a rat tail file in advance to trim the holes, and I also used silicone goo, but you can make a mess with that real quick. It cleans up easy though. |
40 Channel Factory Honda GL1800 CB Radio Kit
ITEM CODE: PG00015
08.21.2009
5 Stars
Instructions not very good. Look for better ones at GL1800riders.com or google for them. That also goes for removing the shelter and all the trim. Don't pay a dealer, you will enjoy the installation - just put aside lots of time and read others instructions 1st. Do NOT remove the trunk. You can get inside the box where it mounts and cut your big hole with a dremel - just watch out for the wires on the other side! |
ITEM: AO18673629
08.21.2009
3 Stars
If you have the Kury' armrests, the hardware that comes with this will not work. If you have those, remove armrests' nuts inside the trunk. The you can push that square piece of chrome off by pushigh out on its studs. Then using the same nuts, go find screws long enough, to reach from inside the trunk, to the holes in the antenna. |
Original Wish List
- No Notes Yet -
VIEW - No Notes Yet -