Alias:
Allan
About:
- Nothing entered yet -
Occupation:
- Nothing entered yet -
Favorite Quote:
- Nothing entered yet -
Member Since:
07.09.2018
Bike 1:
- No Bike 1 -
Bike 2:
- No Bike 2 -
Bike 3:
- No Bike 3 -
Allan has not yet added any pictures.
Allan has not yet written any comments.
Volt Meter With Back Panel
ITEM CODE: WSVOLTMETER, SKU: WSVOLTMETER
08.10.2018
Installed on 2017 GL1800
The installation instructions are not fully accurate for a 2017, but I figured it out. I was able to get the molding piece off by taping the paint, popping the corner with my fingers, and then used a wooden shim to hold up the corner and another wooden shim at the center of the bottom (where the clip is) to get the clip to let loose. That was the hardest part. Getting the lock off is pretty easy. I removed the clip on the back that was holding it on the plastic and that allows for removing the cable. You have to order the extension wire mentioned. The accessory power is on the other side of the bike. So on the clutch side of the bike I removed the storage compartment. You don't need to fully remove the molding piece for that, just get the thin part loose. I then fished the extension wire across the bike with a long zip tie. That worked well. To put the lock in the new panel I removed the voltmeter first. Then reassembled everything. Took me a couple hours but I'm slow and cautious. |
Allan does not have any wish lists.