

|
Drop in fitting. Added a little carpet tape to the bottom to keep it from lifting when things are slid across the trunk mat. Would buy again. |
| Easy install, stops the small stuff from rolling around and scratching this up, would buy or recommend to anyone. |
| Quick and easy install. Works like a charm. |
| Installed and used for a few months. People complain about the instructions, was not hard to figure out. About 15 min to install. Took about four hours of riding to decide on the setting and placement that I like. Would not trade them, really blends nicely. |
| The bike was smooth before - especially compared to my Vulcan. Added 3 oz rear and 2 oz front of the beads. It's a brand new bike! Before, I had shakes and shimmies I didn't even know I had . . . not anymore! I'm ordering some for my Vulcan! |
| Can this product be used in older models? I have a 2004 and want to know if I can use this oil. |
| Really dresses up my Goldwing Trike. I was unable to install them according to the directions but other than that I am very satisfied |
| I had these put on my 08 Wing last year. They are the best investment I have made for my bike. They vent a tremendous amout of air to the riders if you choose, or deflect the cold air off the rider. On cooler days, I open the lower wing and it blows the warm air off the radiators on the rider. I highly recomend them. |
| Buy it! Love mine! |
| Review update. My vent it appears is loose after all. Must have been jamed tight during shipping. I don't understand why the company that makes these is sending out windshields with loose vents. According to others with this problem the fix is to remove the washers around the vent screws. I hope I can get the screws off without removing the windshield cause it ain't comming off. Other than this one problem I like the shield, it gives good protection, cleans easily and does throw off water. Glad I bought it. |
| These look great on the bike and I really like the additional turn signal light |
|
I purchased these a couple months ago and the install was fairly easy but for the extra money there is a better system out there that installs in your trunk. The rubber on this current system tends to get pushed over and not stay straight up. This is with no load on the trunk rack either. Just everyday open and closing of the trunk. I forgot the name of this other trunk system but a vendor attended a Goldwing rally and did the install for about $50.00 and no holes where drilled on top the the trunk exterior to do this. I guess the Baby Buggy system is cheaper but how many times will you have to replace them before they wear out? |