Contact Us
| I had the old style Baker Air Wings on my 99 Wing and was happy with them. So decided to add these new style on my 2010 Wing. These work just as well as the old ones, and I am very happy with them. |
| Great product! I wish i could find a way to put one on the front handel bar too. The passanger handel is the cats meow for this, I think it is a first class product. I cut a small peise of rubber where it clamps on to prevent any marring to the handel. |
|
Spend more than 30 minutes on left side saddle bag strip.. holes would not line up, fit left something to be desired. Didn't do back of saddle bag. Quality of shape & finish definately not up to oem. |
|
I have had several different headsets but would have to say these are the best. They perform better then the well known brand that charges two times as much. Install is quick and easy, the mike an ear inserts work perfectly and are vey easy to adjust for the best sound. Traveling over 70 MPH, my fellow riders could clearly hear me and they reported no mike wind noise. |
| Simple to install and greatly help in deflecting the bugs and debris from rear fenders. Only fault is that the engine guard clamps are impossible to fuly tighten, you must add tape to get a firm hold. |
|
These work, but if you want them to work right you have to cut 1/8" off the top of them. They are just too tall. If you cut them to 3/8" tall, they work as they should. After cutting- 1. The gap is maintained around the trunk lid. 2. No more rattles and paint damage. 3. The trunk opens and closes properly. (Even with the remote.) Cut them. You'll be pleased. |
| easy install, perform very well. THE instructions say ot tighten 1/4 past finger tight, but I find that misleading & under torqued, or else the wings will flap in the breeze. Tighten until 'firm' for positioning the wing. Then ride at 50-60 MPH & see if they will stay in the 'neutral' position & not be forced open or closed. You may need to tighten further, but incrementally. |
| performs as advertised, and like others, would like to see the clamps fit better around the guard, but they seem to hold up well. Wind on lower legs is signficantly reduced. |
| Easy install great leg wind protection and less engine heat. I noticed it a lot the one time I had shorts on. The instruction said the small hole near the inside is from manufacturing and not used BUT with a small tie strape through the hole and around the engine guard it makes for a tighter fit. |
| Vary easy to install and they do a great job of blocking the wind from you and your hands plus adjust to allow more wind if needed. I will enjoy these even more with the colder weather. |
| I added this and a flashing strobe light to my tag and instead of splicing into the wire harness I purchased the trailer light plug and play harness for less than 35.00. A clean install and it uses the battery and its own fuse to protect the bikes electrical system. This a good product bright brake light and noticable running light. |
| I was able to install in 10 min be sure to use locktite I also used a small heater hose split in the middle slid over the front end peace to stop just inside crowl prevents ratle noise. I think this is a must product. |